6 Adjust the safety holder with the cord attached (> 11), to fit the projecting parts and screw the safety holder firmly into place.

≥Screw tightening torque: 80 N0cm (17.98 lbf-ft) to 120 N0cm (26.98 lbf-ft).

≥The safety holder is to minimize the possibility of damage and harm, but it does not guarantee this effect.

≥Keep the safety holders out of reach of children to prevent swallowing.

≥Keep the screws out of reach of children to prevent swallowing.

 

≥ The safety holder is placed diagonally.

 

 

 

 

突起部

 

H Screw with washer (supplied)

 

J Projecting part

ISafety holder (supplied)

7 Attach this unit to the wall mount bracket.

 

K Wall mount

 

bracket

 

(supplied)

L Wall mount

holder

 

 

8 Screw the safety holder onto the wall mount brackets.

≥Screw tightening torque: 80 N0cm (17.98 lbf-ft) to 120 N0cm (26.98 lbf-ft).

≥The safety holders are designed to prevent the unit from falling off the wall mount bracket.

≥Keep the screws out of reach of children to prevent swallowing.

≥Keep the safety holders out of reach of children to prevent swallowing.

M Screw without washer (supplied)

N Safety holder (supplied)

 

 

O Wall mount bracket (supplied)

 P Wall

 

 

 

 

9 Attach the cord to a wall with a screw (not supplied).

≥Make sure that the slack is minimal.

≥Keep the screws out of reach of children to prevent swallowing.

≥Check the strength of the installation location. The position in the wall where the screw is to be attached should be capable of supporting over 33 kg (72.8 lbs). If the strength at any of these positions is lacking, provide sufficient reinforcement.

12

 

Q

Screw eye (not supplied)

R

Cord (not supplied)