There is no audio.
The power of the unit turns off automatically. (When this unit detects a problem, a safety measure is activated and this unit automatically switches to standby mode.)
≥There is a problem with the amplifier.
≥Is the volume extremely high? If so, lower the volume.
≥Is this unit placed in an extremely hot place?
If so, move the unit to a cooler place and wait a few moments and then try to turn it on again.
If the problem persists, turn the unit off and remove the AC power supply cord and consult your dealer. Please be sure to remember the indicators that were blinking and inform the dealer.
Active Subwoofer
No power.
Ensure the AC power supply cord of the active subwoofer is connected properly.
After turning the subwoofer on, it immediately turns off.
Unplug the AC power supply cord and consult your dealer.
No sound from the subwoofer.
≥Check that the active subwoofer is turned on.
≥Check that the wireless link indicator lights green. (> 17)
The wireless link indicator lights red.
≥There is no link between this unit and the active
subwoofer.
jCheck that this unit is turned on.
jEnsure that the digital transmitter is fully inserted into the digital transmitter dock on this unit.
(> 16)
jTurn the active subwoofer off and then back on. Alternatively, turn the active subwoofer off, disconnect the AC power supply cord and then reconnect it.
≥Consult your dealer if the problem persists.
The audio from the subwoofer is interrupted. The active subwoofer is automatically seeking a clear channel. If the interference persists, try moving the other wireless devices to another location outside the range of the active subwoofer or move the active subwoofer nearer to this unit. (> 9)
The wireless link indicator lights red and green alternately.
Turn the subwoofer off, disconnect the AC supply cord and then reconnect it.
Consult your dealer if the problem persists.
Remote control code
When other Panasonic products respond to this unit’s remote control, change the remote control code on this unit and the remote control.
Preparation
≥Turn off all other Panasonic products.
≥Turn on this unit.
Change the remote control to code 2:
1Aim the remote control at this unit’s remote
control sensor.
2Press and hold [MUTE] and [BD/DVD] on the remote control for more than 4 sec.
A
|
|
|
|
|
|
|
|
|
|
|
| BD/DVD |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| TV |
|
| D | DTS | PCM |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Awill blink for 10 sec when the code of this unit is changed.
≥If the unit does not operate after changing the code, repeat steps 1 and 2.
≥To change the remote control to code 1, repeat the steps above, but replace [BD/DVD] with [TV].
Audio information
∫Compatible audio formats
This unit is compatible with the following formats:
Dolby Digital, DTS Digital Surround, 2-channel LPCM and multi-channel LPCM.
Reference
23