Getting started
RQT9660 13
Connect the speaker cables.
≥Insert the wire fully, taking care not to insert beyond the wire insulation.
Drive a screw into the wall.
≥Use the measurements indicated below to identify the screwing positions on the wall.
≥Leave at least 20 mm (25/32q) of space above and on each side of the speaker to allow enough space for fitting the
speaker.
≥The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 kg
(72.8 lbs).
≥Keep the screws out of reach of children to prevent swallowing.
Fit the speaker(s) securely onto the screw(s).
≥Place the speaker that is connected with the speaker cable with a red connector on the observers’ right, and connect with
the speaker cable with a white connector on the observers’ left.
1 Insert the wire fully.
r: White
s: Blue line
2 Press into the groove.
A
At least 30 mm (1
3
/
16
q
)
B‰4.0 mm (5/32q)
C‰7.0 mm to ‰9.4 mm
(9/32q to 3/8q)
DWall or pillar
E5.5 mm to 6.5 mm
(7/32q to 1/4q)
FFront speaker
(Rear view)
G102 mm (4 1/32q)
H37 mm (1 15/32q)
IWall mounting
hole
JWHITE: Left speaker channel (L) KRED: Right speaker channel (R)
DO DO NOT
≥Move the speaker so that the screw is in this
position.
≥In this position, the speaker will likely fall if moved to
the left or right.
Push
Red
White
SC-HTB550_RQT9660_mst.book Page 13 Tuesday, December 20, 2011 1:55 PM