Main unit displays
“F61”
•There is a problem with the amplifier of the system.
•Disconnect the AC mains lead and consult the dealer.
“F70 HDMI”
•Check HDMI connection.
•Switch off the system and then switch it on again.
•Disconnect the HDMI cable.
“F76”
•There is a problem with the power supply.
•Disconnect the AC mains lead and consult the dealer.
System memory reset
Reset the memory when the following situations occur:
•There is no response when buttons are pressed.
•You want to clear and reset the memory contents.
1Switch on this system.
2Press and hold [1] on the main unit for a minimum of 4 seconds.
3Release [1].
“RESET” is shown.
All the settings are set back to the factory preset.
Note:
The remote control code will set back to “REMOTE 1” after memory reset, refer “Remote control code” on how to change to “REMOTE 2”.
Remote control code
When other Panasonic equipment responds to the remote control of this system, change the remote control code for this system.
Preparation
•Switch off all other Panasonic products.
•Switch on this system.
To set the code to “REMOTE 2”
Press and hold [MUTE] and [OK] for a minimum of
4seconds. “REMOTE 2” is shown.
To set the code to “REMOTE 1”
Press and hold [MUTE] and [T] for a minimum of
4seconds. “REMOTE 1” is shown.
Maintenance
To clean this system, wipe with a soft, dry cloth.
•Never use alcohol, paint thinner or benzine to clean this system.
•Before using chemically treated cloth, read the instructions that came with the cloth carefully.
RQT9861
12