Panasonic SC-NE3 owner manual Sound adjustment, Others

Sound adjustment

The following sound effects can be added to the audio output.

1 Press [SOUND] repeatedly to select the effect.

2 Press [3, 4] to select the setting and then press [OK].

Direct-Vocal	“LEVEL 1”, “LEVEL 2” or
Surround	“OFF”.
(D.SURROUND) ≥ The factory preset is “OFF”.
Preset EQ	“HEAVY” (heavy), “SOFT”
(PRESET EQ)	(soft), “CLEAR” (clear),
	“VOCAL” (vocal) or “FLAT”
	(flat/off).
	≥ The factory preset is “HEAVY”.
Bass (BASS) or	Adjust the level (j4 to i4).
Treble (TREBLE)
Dynamic Bass	“ON D.BASS” or
(D.BASS)	“OFF D.BASS”.

≥The factory preset is “ON D.BASS”.

≥You may experience a reduction in sound quality when these effects are used with some sources. If this occurs, turn the sound effects off.

Others

Sleep timer

The sleep timer can turn the unit off after a set time.

1 Press [SETUP] to select “SLEEP”.

2 Press [3, 4] to set the time (in minutes) and then press [OK].

“SLEEP 30” ,. “SLEEP 60” ,. “SLEEP 90” ,. “SLEEP 120”

^--------------------- . “OFF” (Cancel) (---------------------- J

≥The remaining time is indicated on the unit’s display except when other operations are performed.

Display brightness

The brightness of this unit’s display can be changed.

1 Press [SETUP] repeatedly to select “DIMMER”.

2 Press [3, 4] to select “ON” and then press [OK].

Automatic standby

As a factory preset, this unit will always turn off automatically if there is no sound output and no operation for approx. 30 minutes.

To cancel this function

1	Press [SETUP] repeatedly to select
2	“AUTO OFF”.
	Press [3, 4] to select “OFF” and then press	ENGLISH
	[OK].

≥ To turn automatic standby on, select “ON” in step 2.

≥ When connected to a Bluetooth® device, the automatic standby function does not work.

Wi-Fi signal strength

To check the Wi-Fi signal strength where the unit is located.

Preparation

Connect this unit to the wireless network. (l 7)

1 Press [SETUP] repeatedly to select “SIG.LEVEL” and then press [OK].

≥The unit’s display shows “LEVEL ”. (“ ” stands for a number.)

2 Press [OK] to exit this display mode.

≥It is recommended to have a signal strength of “3”. Change the position or angle of your wireless network router or the unit if the indication is “2” or “1” and see if the connection improves.

≥If “LEVEL 0” is displayed, this unit cannot establish a link with the wireless network router. (l 16)

≥This function does not work when “D.CONNECT” is set to “ON”.

Network standby

This unit can turn on automatically from standby mode when this unit is selected as the AirPlay speakers.

Preparation

Connect this unit to the wireless network. (l 7)

1 Press [SETUP] repeatedly to select “NET STNBY” and then press [OK].

2 Press [3, 4] to select “ON” and then press [OK].

≥To cancel the dimmer, select “OFF” in step 2.

≥To cancel this function, select “OFF” in step 2.

≥The factory preset is “OFF”. If this function is set to “ON” the standby power consumption will increase.

13

VQT4U49