2 Speaker connections
≥Be careful not to cross 
speakers.
Main unit
Setup
3
1
![[FM\indoor\antenna]](/images/new-backgrounds/11274/1127413xi5.webp){kind=small}
2 Insert the wires, taking care not to insert beyond the ![[AM\loop\antenna]](/images/new-backgrounds/11274/1127413xi6.webp){kind=small}
wire insulation.
i: White
SURROUND
Lch
3
j: Blue
Insert the wires correctly.
3SURROUND (L)
4 SURROUND (R)
1 FRONT (L)
2 FRONT (R)
5 CENTER
6 SUBWOOFER
Speaker cable sticker (included)
Attach the corresponding speaker cables with the
Simple
3 Radio antenna connections
≥Keep loose antenna cables away from other wires and cables.
connections
[FM\indoor\antenna]
(included)
Affix this end of the antenna where reception is best.
![[XM\antenna]](/images/new-backgrounds/11274/1127413xi7.webp){kind=small}
1
Adhesive tape
3
2 | FM ANT |
| 75 |
| LOOP |
|
| ANT GND | White |
| LOOP | |
| AM | Red |
Push! | ANT | |
EXT |
| |
|
|
[AM\loop\antenna]
(included)
Stand the antenna up on its base. Place the antenna where reception is best.
[XM\antenna]
(not included)
Use an XM Connect & Play antenna, or XM Passport
≥Subscription is required to receive XM Satellite Radio.
Refer to page 28 for details.
Cable
BlackClick!
XM
Using an FM/AM outdoor antenna (optional)
Use outdoor antenna if FM/AM radio reception is poor.
≥Disconnect the antenna when the unit is not in use.
≥Do not use the outdoor antenna during an electrical storm.
FM outdoor antenna
[Using a television antenna (not included)]
Leave the AM loop antenna connected.
FM ANT | 75 ≠ coaxial cable§ | |
| 75 | (not included) |
| ||
|
| |
LOOP |
|
ANT GND |
|
LOOP | Antenna plug |
AM | (not included) |
ANT |
|
EXT |
|
5 to 12 m
(16 to 39 feet)
≥Disconnect the FM indoor antenna.
≥The antenna should be installed by a competent technician.
AM outdoor antenna
[Using a vinyl wire (not included)]
Run a piece of vinyl wire horizontally across a window or other convenient location.
§Rework your outdoor antenna’s 75 ≠ coaxial cable as follows.
1 Remove a piece of the outer | 2 Carefully pull the tabs apart | 3 Install the coaxial cable. | 4 Attach the cover. | ||
vinyl insulator. |
| to remove the cover. | Clamp the cable conductor, and |
| |
|
|
|
| wind it on so that it does not |
|
|
|
|
| contact anything else. |
|
10 mm (13/32z) |
| |
|
| |
|
|
|
|
| |
10 mm (13/32z) | Peel back | | |
|
|
|
|
|
|
| |
RQTX0069
7 mm (9/32z) | Clamp with pliers |
| |
7 | |||
|
| ||
|
|
|
