Panasonic SC-ZT2 Functions and settings, Setting distances, Setting 7.1-channelvirtual surround

Functions and settings

Setting distances

Functions and settings

Play

To return to the previous display/ To cancel during setting operation: Press [ RETURN].

You can make this setting when using the surround speakers. This setting is not displayed under different conditions.

By setting the distance from front/surround speakers to the listening-viewing position, the sound delay time is automatically calculated and adjusted so that sound reaches the listener at the same time.

1. Press and hold [–SETUP, OFF] for about 2 seconds.

The setting items are displayed. (➜ page 21)

2.Press [w][q] to select “DISTANCE ” and press [OK].

3.Press [w][q] to select a speaker to set and press [OK].

FRONT : Front speakers

SURR : Surround speakers

4. Press [e][r] to select the distance and press [OK].

Adjustment range: 1.0 to 10.0 meter (3.0 to 30.0 ft (feet))

Factory setting: Front 3.0 meter (10.0 ft (feet))

Surround 1.5 meter (5.0 ft (feet))

5.Press [ RETURN] several times to select “EXIT ” and press [OK] to finish the setting.

Note

Radio waves from this system reach the maximum range of 15 m (49 feet) within the same room.

Setting 7.1-channel virtual surround

When playing back 7.1-channel LPCM signals, you can enjoy wider sound field effects as if another speaker is added. Factory setting is “AUTO ”.

When you do not want to use 7.1-channel virtual surround effect, select “OFF ” in this setting.

1. Press and hold [–SETUP, OFF] for about 2 seconds.

The setting items are displayed. (➜ page 21)

2.Press [w][q] to select “7.1CH VS ” and press [OK].

3.Press [e][r] to select “OFF ” and press [OK].

AUTO : The setting is switched between ON and OFF depending on the input signals.

Only when 7.1-channel LPCM signals are input, 7.1-channel virtual surround is ON (When other signals are input, this setting is OFF).

OFF : 7.1-channel virtual surround is always OFF.

Factory setting: AUTO

4.Press [ RETURN] several times to select “EXIT ” and press [OK] to finish the setting.

Reducing Standby power consumption (In Standby condition (HDMI off mode))

Standby through function (➜ pages 9, 28) does not work in this mode if you have connected through the HDMI terminal.

VIERA Link “HDAVI Control” (➜ page 18) will not function when this system is off.

1. Press and hold [–SETUP, OFF] for about 2 seconds.

The setting items are displayed. (➜ page 21)

2.Press [w][q] to select “HDMI ” and press [OK].

3.Press [w][q] to select “STNBY ” and press [OK].

4.Press [e][r] to select “OFF ” and press [OK].

OFF : Standby power consumption reduced (approx. 0.2 W)

ON : “Standby through” is activated when this system is turned off. (Normal power consumption)

Factory setting: ON

5.Press [ RETURN] several times to select “EXIT ” and press [OK] to finish the setting.

22

VQT2R70