Error messages
Display |
| Check point/Cause/Countermeasure |
| Pages |
|
|
|
| |
CANCEL MUTE FUNCTION (Scrolling) | • | The test signal is not output while muting is on. Cancel muting for operation. | 20 | |
|
|
|
|
|
MUTE (Blinking) | • | This is always displayed while muting is on. |
| 20 |
|
|
|
|
|
NOT POSSIBLE FOR | • | You cannot use Dolby Virtual Speaker, SFC and Dolby Pro Logic | for dual | — |
THIS INPUT SOURCE (Scrolling) |
| sounds. |
|
|
|
|
|
|
|
NOT POSSIBLE FOR | • | You cannot use Dolby Virtual Speaker, SFC and Dolby Pro Logic | effect with | 17 |
THIS PCM SOURCE (Scrolling) |
| PCM signals with sampling frequency of over 48 kHz. |
|
|
|
|
|
|
|
NOT POSSIBLE WHEN USING | • | You cannot use the sound field effects when using headphones. |
| 25 |
HEADPHONES (Scrolling) |
| |||
|
|
|
| |
|
|
|
| |
| • | Set the same remote control code for this main unit and remote control. When “REMOTE 2 ” | 24 | |
REMOTE 2 |
| is displayed, set the code to “2 ” on the remote control in step 4 of procedure “When other |
| |
| equipment (mini component system, AV amp, etc.) manufactured by Panasonic operates |
| ||
REMOTE 1 |
|
| ||
| with the remote control operations of this system”. When “REMOTE 1 ” is displayed, set the |
| ||
|
|
| ||
|
| code to “1 ” on the remote control in step 4 in the same way. |
|
|
|
|
|
| |
SWITCH OFF POWER | • | While “F70 ” is displayed, all operations but turning ON/OFF operation are not | — | |
(Scrolling) |
| available. Turn off the system, unplug the AC power supply cord, and consult your dealer. |
| |
|
|
|
| |
TURN OFF DTS FIX MODE | • | When each input is fixed to DTS (DTS FIX), the sound field effects cannot be | 24 | |
(Scrolling) |
| canceled even if you press |
|
|
|
|
|
| |
U701 | • | The equipment connected by the HDMI cable is not compatible with this system’s copyright protection technology. | — | |
|
|
|
| |
| • | A problem has occurred with the HDMI connection. Try the following to correct | — | |
|
| the problem. Consult your dealer if the error code remains on the display. |
| |
U703 |
| – Turn the connected equipment off and on again. |
|
|
–Disconnect the HDMI cable then reconnect it.
–Do not connect more than 2 sets of equipment to this system’s output.
U704 | • The system received incompatible video signals through HDMI connection. | — | ||
Check the settings of the connected equipment. |
| |||
|
| |||
Using with headphones |
| |||
Turn down the volume closest to the minimum value. |
| Note |
| |
• Plug type: ø 3.5 mm (1/8 in.) stereo mini plug | • | Avoid listening for prolonged periods of time to prevent hearing | ||
| W (Headphone) jack |
| damage. |
|
|
| • | ||
|
|
| output. (2CH MIX) |
|
| Headphones |
| However, for DVD audio, the front left and right signals are output. | |
| (not included) |
|
|
|
headphones/Specifications
Specifications
MAIN UNIT |
|
|
|
g PRE AMPLIFIER SECTION |
| ||
Input sensitivity / Input impedance |
| ||
TV, AUX3 | 600 mV / 47 kΩ | ||
S/N ratio (IHF A) |
|
| |
BD/DVD, TV, AUX1, |
|
| |
AUX2 (Digital Input) | 80 dB (IHF '66) | ||
Tone controls |
|
| |
BASS | 50 Hz, + 6 to | ||
TREBLE | 20 kHz, + 6 to – 6 dB | ||
Input/Output terminal |
|
| |
|
|
|
|
Audio Input |
|
| |
Analog Input ( TV, AUX3 ) | 2 | ||
Optical Digital Input | ( TV, AUX2 ) | 2 | |
Audio Output |
|
| |
Audio Output ( Front L/R, Surround L/R ) | 4 | ||
Subwoofer Output |
| 1 | |
Headphone Output | ( 16 to 64 Ω ) | 1 | |
Video/Audio |
|
| |
HDMI Input ( BD/DVD, AUX1 ) | 2 | ||
HDMI Output ( TO TV (ARC)) | 1 |
This system supports “HDAVI Control 4” function.
g MAIN UNIT GENERAL |
|
|
|
Power supply | AC 120 V, 60 Hz | ||
Power consumption |
| 16 W | |
In standby condition |
| 0.5 W |
|
In standby condition ( HDMI off mode ) | 0.2 W | ||
|
|
|
|
Dimensions ( W x H x D ) | 430 mm x 59 mm x 262 mm | ||
| |||
Mass [ Weight ] | Approx. 2 kg (4.4 lb.) | ||
Operating temperature range | 0°C to 40 °C (32°F to 104 °F) |
Operating humidity range 20 % to 80 % RH (no condensation)
g WIRELESS SECTION |
|
Frequency of the using band | 2.4000 GHz to 2.4835 GHz |
Number of using channels | 3 |
The reaching distance | 15 m (49 ft)∗1 |
∗1 It is under the condition as follows. | |
At same room indoor, there is not an obstacle | |
between the main unit and the speaker. | |
And installing a main unit in the position with | |
equal to or more than 50 cm height. |
SPEAKER |
|
|
|
g POWER AMPLIFIER SECTION∗2 |
| ||
RMS output power |
|
| |
10 % total harmonic distortion |
| ||
Woofer Speaker ch | 60 W (100 Hz, 3 | Ω) | |
Mid High Speaker ch | 20 W (1 kHz, 8 | Ω) | |
System Total Power∗3 | 160 W (80 W x 2) |
FTC output power |
|
|
1.0 % total harmonic distortion |
| |
50 Hz to 250 Hz | Woofer Speaker ch 37 | W (3 Ω) |
250 Hz to 20 kHz Mid High Speaker ch 13 | W (8 Ω) | |
System Total Power∗3 | 100 W (50 W x 2) |
gSPEAKER SECTION∗2
Woofer part | 12 cm cone type x 1 | |
Mid High part | 2.4 x 10 cm flat type x 4 | |
g SPEAKER GENERAL∗2 | ||
Power supply | AC 120 V, 60 Hz | |
Power consumption | 20 W | |
|
|
|
Wireless Link Standby | 0.8 W |
|
In Standby condition | 0.1 W | |
|
|
|
Dimensions ( W x H x D ) | 290 mm x 1231 mm x 290 mm | |
| ||
Mass [ Weight ] | Approx. 3.9 kg (8.6 lb.) |
Operating temperature range 0°C to 40°C (32°F to 104°F) Operating humidity range 20 % to 80 % RH (no condensation) ∗2: per 1 speaker
∗3: use 2 speakers
Note: 1. Specifications are subject to change without notice.
2.Total harmonic distortion is measured by the digital spectrum analyzer.
3.Total harmonic distortion is measured by using AES17 filter.
Troubleshootingother informationand Error messages/Using with
25
VQT2R70