Panasonic SL-S292 Power Supply Preparations, Hold Function Location of Controls

Models: SL-S292

1 6
Download 6 pages 36.79 Kb
Page 2
Image 2

Power Supply Preparations

Refer to the specifications (page 6) for information on operating times when using rechargeable batteries or dry-cell batteries.

Using the AC adaptor (not included)

Be sure to obtain the optional AC adaptor RP-AC46.It is available through your Panasonic dealer.

2 Connect the AC adaptor.

(Refer to “Using the AC adaptor” for connection instructions.)

Recharging starts and the “H” charging indicator flashes on and off on the unit’s display. When the rechargeable batteries fully recharge the charging indicator disappears.

CAUTION:

Use only car adaptor, Model: SH-CDC9 manufac- tured by Matsushita Electric Industrial Co.,Ltd.

Using dry-cell batteries (not included)

Connect the AC adaptor.

DC IN jack (KDC IN 4.5 V)

Back panel of the unit

Household AC outlet

3 When recharging is complete, un- plug the AC adaptor from the household AC outlet and the DC IN jack.

Note!

Rechargeable batteries have a service life of approxi- mately 300 charge-discharge cycles. If the operating time on one full charge becomes noticeably shorter

After disconnecting the AC adaptor, insert two “AA” (LR6) alkaline batteries.

The procedure for inserting and removing dry-cell batteries is identical to that for rechargeable bat- teries.

Battery indicator

AC adaptor

Conserving power

To save power when the unit is not to be used for a long time, unplug the AC adaptor from the household AC outlet. Reprogram tracks if necessary before use.

Using rechargeable batteries (not included)

Obtain the optional rechargeable batteries.

Make sure to recharge the batteries before using them. The unit cannot be used to charge rechargeable batter- ies other than those specially designed for it.

Optional batteries (P-3GAVA/2B)

Recharging procedure

1 Insert the special rechargeable bat- teries into the unit.

 

 

2

1

3

-

+

 

 

than it used to be, the battery has reached the end of its service life and should be replaced.

Recharging may only be performed when the unit is powered off.

The AC adaptor and rechargeable batteries may be- come warm while recharging is in progress. This is not a malfunction.

If the battery lid

Removing batteries

comes loose

Push up on the battery

Slide the lid back into

in the direction indicat-

place horizontally.

ed by the arrow. Then

 

lift it out.

Using the car adaptor (not included)

Be sure to obtain the car adaptor (SH-CDC9), available as an optional accessory.

The car adaptor can be used to recharge the unit’s bat- teries while in the car.

Battery indicator

This indicator flashes on and off when the batteries are almost out of power. Power is cut off completely a short while later.

Rechargeable batteries: Recharge batteries.

Dry-cell batteries: Replace batteries with new ones.

Note!

The length of time the unit will continue to operate be- tween when the battery indicator starts flashing and when the power is cut off differs depending on the type of batteries used.

The battery indicator may not flash if rechargeable batteries other than those designated by Panasonic are used.

If the unit malfunctions or freezes during use, then disconnect the power sources (the AC adaptor and batteries).

Re-connect the power source and continue op- eration.

HOLD Function

 

Location of Controls

HOLD

A B CD

HOLD mode

This function causes the unit to ignore

(” indication

short, accidental button presses. (The

When the unit is in HOLD status, press-

disc lid can still be opened and closed.)

ing any button (other than the OPEN

The HOLD function prevents the

button) causes the indication “(” to

appear on the display.

following:

When the unit is powered off

Powering on the unit accidentally

The “(” indication appears only

(which can cause the batteries to run

when [1 ;] is pressed.

down).

 

Play being cut off unexpectedly in the

Before operating the buttons

middle of a selection.

Be sure to move [HOLD] to release

 

To use the HOLD function

the unit from the hold mode.

Set [HOLD] to the HOLD position.

 

 

 

 

 

N

E F G HIJ KLM

O

Back panel of

the unit

 

 

 

A Skip/search buttons

H Headphone volume control

(:, 9 6 , 5)

 

(VOLUME)

 

B Display

I Anti-shock button (A.SHOCK)

C Stop/operation off button

J S-XBS button (S-XBS)

(, OPR OFF)

K Headphone jack (Ë)

D Play/pause button (1 ;)

L Play mode selector

E Repeat button (`)

 

(RESUME, RANDOM, NORMAL)

F Memory/recall button

M Hold switch (HOLD)

(MEMORY/RECALL)

N CD release button (PUSH)

G Open button (OPEN)

O DC IN jack (KDC IN 4.5 V)

2

Page 2
Image 2
Panasonic SL-S292 important safety instructions Power Supply Preparations, Hold Function Location of Controls