SwitchBlade x8112 Chassis Switch Installation Guide

Replacing the AT-SBxPWRSYS1 DC Power Supply

To remove an AT-SBxPWRSYS1 DC Power Supply from the chassis, perform the following procedure:

1.Turn off the circuit breaker to the AT-SBxPWRSYS1 DC Power Supply.

2.Turn off the On/Off switch on the front panel of the power supply. Refer to Figure 99 on page 150.

3.Use a #2 screwdriver to loosen the screw on the locking handle. Refer to Figure 138.

Note

Do not lift the locking handle yet.

Figure 138. Loosening the Screw on the Locking Handle

209

Page 209
Image 209
Allied Telesis X8112 manual Replacing the AT-SBxPWRSYS1 DC Power Supply, Loosening the Screw on the Locking Handle