Entering the

AlliedWare Plus

Operating System

Commands

SwitchBlade x8112 Chassis Switch Installation Guide

2.Connect the other end of the cable to an RS-232 port on a terminal or personal computer with a terminal emulation program.

3.Configure the VT-100 terminal or terminal emulation program as follows:

Baud rate: 115,200 bps

Data bits: 8

Parity: None

Stop bits: 1

Flow controller: None

Note

The port settings are for a DEC VT100 or ANSI terminal, or an equivalent terminal emulator program.

4.Press Enter. You are prompted for a user name and password.

5.Enter the default user name and password. They are “manager” and “friend” (without the quotes), respectively

Note

User names and passwords are case sensitive.

The local management session starts and the command line interface (CLI) prompt is displayed.

To confirm the operations of the chassis with the commands in the AlliedWare Plus Operating System, perform the following procedure:

1.Enter the SHOW VERSION command in the User Exec or Privileged Exec mode to display the software version number of the management software on the controller card. An example of the command is shown in Figure 131 on page 184.

183

Page 183
Image 183
Allied Telesis X8112 manual Entering AlliedWare Plus Operating System Commands