SwitchBlade x8112 Chassis Switch Installation Guide
Powering On the AT-SBxPWRSYS1 AC System Power Supply
The procedure in this section explains how to power on the AT- SBxPWRSYS1 AC System Power Supplies in slots C and D on the front panel. If you have not already installed the power supplies, refer to “Installing the
Note
If the chassis has both
Power Supplies, you may power on the power supplies in any order.
The power supplies may also be powered on simultaneously.
To power on the chassis, perform the following procedure:
1.Identify AC sockets C and D in the recessed panel on the back panel of the chassis, shown in Figure 93. These sockets are for the AT- SBxPWRSYS1 System Power Supplies in slots C and D on the front panel of the chassis.
C 
A
D 
B
Figure 93. AC Sockets on the Rear Panel of the AT-SBx8112 Chassis
2.Plug the AC power cord that comes with the power supply into a plug whose corresponding slot on the front panel has a system power supply.
143
