SBx STATUS LEDs
SwitchBlade x8112 Chassis Switch Installation Guide
The SBx LINECARD STATUS LEDs display general status information about the Ethernet line cards and controller cards. There is one LED for each slot. If the chassis has two controller cards, the SBx Status LEDs on both cards are active. The LEDs are defined in Table 11.
Table 11. SBx LINECARD STATUS LEDs
LEDs | State | Description |
|
|
|
|
|
|
| Off | Indicates that the slot is empty. |
|
|
|
| Solid Green | Indicates that the Ethernet line or controller |
|
| card is operating normally. |
|
|
|
| Flashing Green | Indicates that the card is booting up, |
|
| running in test mode, or loading its |
1 to 12 |
| configuration settings. |
|
| |
| Solid Amber | Indicates that the card is in an |
|
| Possible causes are: |
|
| An Ethernet line card that displays this |
|
| LED state may have encountered a |
|
| problem initializing the management |
|
| software. |
|
| An Ethernet line card that displays this |
|
| LED state might not be able to boot up |
|
| because the controller card does not |
|
| have the appropriate load file and |
|
| needs to be updated to the most recent |
|
| release of the AlliedWare Plus |
|
| Operating System. |
|
| A standby master controller card that |
|
| displays this LED state may have been |
|
| disabled by the active master controller |
|
| card because the cards have |
|
| incompatible versions of the AlliedWare |
|
| Plus Operating System and were |
|
| unable to resolve the problem, possibly |
|
| because of insufficient free flash |
|
| memory. |
|
| You may remove a line or controller card |
|
| from the chassis when it is in this state. |
|
|
|
| Flashing Amber | Indicates that the card is reporting a fault |
|
| condition. Use the management commands |
|
| to determine the specific problem. |
|
|
|
47
