SwitchBlade x8112 Chassis Switch Installation Guide

Note

Do not remove the dust plug from the SFP+ slot if you are not installing the transceiver at this time. The dust plug protects the line card from dust contamination.

2.Orient the connector on the AT-SP10TW cable so that the release tab is on top, as shown in Figure 91.

Figure 91. Release Tab on the AT-SBx81XS6 Line Card

3.Slide the connector into the slot until it clicks into place, as shown in Figure 92.

Figure 92. Installing the AT-SP10TW Cable in the AT-SBx81XS6 Line

Card

137

Page 137
Image 137
Allied Telesis X8112 manual Installing the AT-SP10TW Cable in the AT-SBx81XS6 Line Card