Allied Telesis X8112 manual Installing the AT-SBxPWRPOE1 PoE Power Supply

SwitchBlade x8112 Chassis Switch Installation Guide

Installing the AT-SBxPWRPOE1 PoE Power Supply

This section contains the installation procedure for the AT-SBxPWRPOE1 Power Supply, for the PoE+ ports on the AT-SBx81GP24 PoE Line Card. For background information, refer to “AT-SBxPWRPOE1 Power Supply” on page 55.

Caution

The electronic components in the AT-SBxPWRPOE1 PoE Power Supply can be damaged by electro-static discharges (ESD). Follow the procedure in “Protecting Against Electrostatic Discharge (ESD)” on page 88 to guard against ESD damage when unpacking and installing the power supply.

To install the power supply, perform the following procedure:

1.Choose a slot for the AT-AT-SBxPWRPOE1 System Power Supply in the chassis.

You may install it in either slot A or B, shown in Figure 43 on page 89.

2.Raise the handle on the blank panel covering the selected slot and slide the panel from the chassis. Figure 50 on page 96 illustrates the removal of the blank panel from slot A.

95