Allied Telesis X8112 manual Replacing AT-SBxPWRSYS1 AC and AT-SBxPWRPOE1 Power Supplies

Chapter 10: Replacing Modules

Replacing AT-SBxPWRSYS1 AC and AT-SBxPWRPOE1 Power Supplies

This section contains the procedure for removing AT-SBxPWRSYS1 AC and AT-SBxPWRPOE1 Power Supplies from the AT-SBx8112 Chassis.

Note

The illustrations in the procedure show the removal of an AT- SBxPWRSYS1 AC Power Supply from slot D. The procedure is the same for all power supply slots.

To remove an AT-SBxPWRSYS1 AC or AT-SBxPWRPOE1 Power Supply from the chassis, perform the following procedure:

1.Disconnect the AC power cord for the power supply from the AC power source and the corresponding AC socket on the back panel of the chassis. The figure in Figure 133 shows the removal of the power cord from connector D, which corresponds to slot D on the front panel.

Figure 133. Disconnecting the AC Power Cord from the AC Socket on the

Back Panel

204