SwitchBlade x8112 Chassis Switch Installation Guide

Figure 68. Aligning the AT-SBx81CFC400 Card in the Chassis Slot

7. Carefully slide the card into the slot.

Caution

It is important to keep the card level with the chassis as you slide it into the slot. You might damage the components on the top or bottom of the card if you slide it in at an angle. Refer to Figure 62 on page 109.

Caution

Do not force the AT-SBx81CFC400 Card into the slot. If you feel resistance, remove it and try again. Be sure that the edges of the card are properly aligned with the card guides.

8.When you feel the card make contact with the connector on the backplane of the chassis, carefully close the two locking levers on the front panel of the controller card to secure it in the chassis, as shown in Figure 69 on page 114.

113

Page 113
Image 113
Allied Telesis X8112 manual 113