Allied Telesis X8112 manual Attaching the Power Wires to the Straight Terminal Lugs 157

SwitchBlade x8112 Chassis Switch Installation Guide
Figure 110: Attaching the Power Wires to the Straight Terminal Lugs	157
Figure 111: On/Off Switch on the AT-SBxPWRSYS1 DC Power Supply	158
Figure 112: Opening the Plastic Cover	159
Figure 113: Removing the Terminal Screws	160
Figure 114: Connecting the Positive (+) Power Wire with a Straight Terminal	161
Figure 115: Connecting the Negative (-) Power Wire with a Straight Terminal	162
Figure 116: Closing the Plastic Cover over the Terminal Connectors	163
Figure 117: Tightening the Handle Locking Screw	164
Figure 118: Stripping the Power Wires	165
Figure 119: Attaching the Power Wires to the Right Angle Terminals	165
Figure 120: Removing the Plastic Cover	166
Figure 121: Removing the Terminal Screws	167
Figure 122: Connecting the Positive (+) Power Wire with a Right Angle Terminal	168
Figure 123: Connecting the Negative (-) Power Wire with a Right Angle Terminal	169
Figure 124: Tightening the Handle Locking Screw	170
Figure 125: Stripping Solid or Stranded DC Power Wires	171
Figure 126: Connecting the Positive Wire With Bare Wire	172
Figure 127: Connecting the Negative Lead Wire with Bare Wire	173
Figure 128: Switch Initialization Messages	176
Figure 129: Switch Initialization Messages (Continued)	177
Figure 130: Connecting the Management Cable to the Console RS-232 Port	182
Figure 131: SHOW VERSION Command	184
Figure 132: SHOW CARD Command	184
Figure 133: Disconnecting the AC Power Cord from the AC Socket on the Back Panel	204
Figure 134: Lifting the Locking Handle on the Power Supply	205
Figure 135: Removing the Power Supply from the Chassis	206
Figure 136: Installing a Blank Power Supply Slot Cover	207
Figure 137: Lowering the Locking Handle on the Power Supply Slot Cover	208
Figure 138: Loosening the Screw on the Locking Handle	209
Figure 139: Opening the Plastic Window over the Terminal Block	210
Figure 140: Removing the Negative Lead Wire	211
Figure 141: Removing the Positive Lead Wire from the Terminal Block	212
Figure 142: Reinstalling the Screws on the Positive and Negative Terminals	213
Figure 143: Closing the Plastic Cover	214
Figure 144: Removing the Grounding Wire	215
Figure 145: Reinstalling the Nut and Washer on the Grounding Post	216
Figure 146: Lifting the Locking Handle and Removing the Power Supply	217
Figure 147: Installing a Blank Power Supply Slot Cover	218
Figure 148: Lowering the Locking Handle on the Power Supply Slot Cover	219
Figure 149: Loosening the Screw on the AT-SBxFAN12 Fan Module	225
Figure 150: Loosening the AT-SBxFAN12 Fan Module from the Backplane Connector	226
Figure 151: Withdrawing the AT-SBxFAN12 Fan Module 51 mm (2 In.) from the Chassis	227
Figure 152: Removing the AT-SBxFAN12 Fan Module from the Chassis	228
Figure 153: Installing a New AT-SBxFAN12 Fan Module	229
Figure 154: Securing the AT-SBxFAN12 Fan Module on the Backplane Connector	230
Figure 155: Tightening the Screw on the AT-SBxFAN12 Fan Module	231
Figure 156: Pin Numbers for RJ-45 and RJ Point 5 Ports (Front View)	239

11