Chapter 10: Replacing Modules
Replacing the AT-SBxFAN12 Fan Module
Removing the
AT-SBxFAN12
Fan Module
This section contains the procedures for replacing the
Caution
Although the fan module is hot swappable and can be replaced while the chassis is powered on, the chassis may overheat if it is operated for more than one or two minutes without a fan module.
Warning
The fan module has hazardous moving parts. Keep fingers away from moving fan blades.
Note
Only authorized service technicians should replace the fan module.
Caution
The fan module is heavy. Be sure to use both hands to hold the module as you remove it from the chassis.
To remove the fan module from the chassis, perform the following procedure:
1.If necessary, disconnect or reroute network cables that are blocking access to the fan module.
2.Use a #2 Phillips head screwdriver to loosen the screw at the base of the fan module. Refer to Figure 149 on page 225.
224
