Panasonic SL-SX240, SL-SX280 Using the Wired Remote Control, How to use the wired remote control

≥Car mounting kit (SH-CDF20)

Note when using the car mounting kit (SH-CDF20)

Using the Wired Remote Control

SL-SX280

The remote control can be operated regardless of the hold mode of the unit.

Preparation:

How to use the wired remote control

Release the remote control from the HOLD mode.

HOLD

∫Operation confirmation tones

When an operation button is pressed, a confirmation tone sounds. Refer to the parentheses in the illustration for the different types of confirmation tones.

Press once during off or stop mode.

To start play

(Beep)

Press once during play.

To stop play

(Beep...Beep)

Press and hold during play or stop mode.

To turn off the

unit

(Beep...Bee...p)

	Press once during play.
	(Press [:] twice to skip to the be-
Skipping	ginning of the previous tracks.)
tracks			Backward
			(Beep Beep
			Beep)
Searching			Forward
through tracks			(Beep Beep)
	Press and hold during play.
	≥The volume range is 0–25. (Press
	and hold to change the volume suc-
	cessively.)
	≥A tone (beep-beep) sounds when
	you reach the minimum or maximum
To adjust the	volume.
volume
	Decrease	VOL	Increase
	(Beep)		(Beep)

Using the Unit with Optional Accessories Maintenance

Using the unit with an audio system	Using the unit with a car audio
	system
Using a stereo phono cable (not included), you can lis-
ten to CDs on your audio system.	Items to be purchased
≥Turn off this unit and the other equipment before con-	For connection to the car audio system:
	Car stereo cassette adaptor (SH-CDM10A)
nection.	Connect the car stereo cassette adaptor to the
≥Do not connect the cable to the PHONO jacks on the
	unit’s headphone jack.
amplifier.
	(When doing this, set this unit's volume to 10.)
≥Obtain the optional connecting cable if the other
equipment comes with mini-phone jacks.	For securing the unit and connecting the power
≥Set the unit’s volume to 10, then adjust the volume	supply:
level on the other equipment.	≥Car adaptor (SH-CDC9)

If the surfaces are dirty

To clean this unit, wipe with a soft, dry cloth.

If the surfaces are extremely dirty, use a soft cloth dipped in a soap-and-water solution or a weak deter- gent solution.

≥Never use alcohol, paint thinner or benzine to clean this unit.

≥Before using chemically treated cloth, read the instruc- tions that came with the cloth carefully.

Maintaining the lens

Open the lid and clean the lens as shown in the figure. Use a cotton swab to gently wipe off any finger-prints. Recommended product: Lens cleaner kit (SZZP1038C)

SL-SX280

≥You can connect speakers, active or otherwise, with an impedance of 1 k≠ or less to the headphone jack.

Headphone jack (Ë)

Bracket

Screwdriver

Note1

1Remove the screw from the bracket at the rear of the car mounting base.

2Replace the screw in the lower hole of the bracket.

Lens

Air blower for camera lens

Lens

Other equipment

(White) L To CD or AUX terminals

(Red) R

Stereo phono cable (not included)

≥When you switch off the car, volume and sound quality may return to the original settings and the resume function may work even if you change the disc.

≥It may not be possible to use the unit with some types of car stereos owing to restrictions imposed by the construction of the car stereo cassette adaptor.

For further details, refer to the instructions of the part concerned.

5