3
Maintenance
Clean with a soft, dry cloth.
Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine.
SpecificationsCare and use
Before requesting service, make the following checks. If you are in doubt
about any of the check points, or if the solutions indicated in the chart do
not solve the problem, consult your dealer.
•There is no audio data in the player.
•The battery is dead. Change the battery.
•The HOLD switch is on.
•Memory is full.
•You have tried to record more than 383 tracks into
a play list.
NO TRACK PLAY
LOW BATTERY
HOLD
FULL MEMORY
TRACK OVER
Troubleshooting guide
• Leave some slack in the cord of the earphones and the neck lanyard if you wind
them around the unit.
Do not;
• disassemble, remodel, drop, or allow the unit to get wet.
• use or store in locations directly exposed to sunlight, corrosive gases, a heat vent, or
a heating appliance.
• use or store in humid or dusty locations.
• use force to open the battery lid.
• play your headphones or earphones at a high volume.

Batteries

•
Do not peel off the covering on batteries and do not use if the covering has been peeled off.
• Align the poles + and - correctly when inserting batteries.
• Remove batteries if you do not intend to use the unit for a long time.
• Do not throw into fire, short-circuit, disassemble, or subject to excessive heat.
• Keep out of the reach of small children.
Accidental swallowing of batteries can result in stomach and intestinal damage.

Allergies

Discontinue use if you experience discomfort with the earphones or any other parts that
directly contact your skin. Continued use may cause rashes or other allergic reactions.
Caution:
• Use only the provided shielded interface cables when connecting to computer.
• To reduce risk of radio interference caused by headphone, earphone or
microphone cable, only purchase accessories with cable length less than 3 m.
This product may receive radio interference caused by mobile telephones during
use. If such interference is apparent, please increase separation between the
product and the mobile telephone.
MUSIC mode
(→page 4)
Location of Controls Displays
REC/STOP
Operation
lamp
Microphone
–MODE
Volume
Turn on, off
(Press and hold)/
Play/Stop
Battery lid
Earphones jack
(3.5 mm stereo)
USB port
HOLD switch
Skip/Search
Display
(→below)
Display Example: MUSIC

Low-power consumption display

• Power consumption is reduced by dimming the brightness of the display's back
light. You can set the time until the display changes to a low-power consumption
one. (→page 6 “SYSTEM, BACKLIGHT”)
• Press any key on the unit to cancel the low-power consumption display. When the
back light lights, perform the next operation.
SYSTEM mode (→page 6)
LEARN mode (→page 4)
FM RADIO mode
(→page 5)
IC RECORDER
mode
(→page 5)
(back)
Memory size:
Supported sampling frequency:
Supported bit-rates:
No. of channels:
Frequency response:
Mic S/N:
Radio Frequency range (FM):
Output:
Power supply:
Approximate play times:
Approximate recording times:
Cabinet dimensions (W××H××D):
Mass:
• Specifications are subject to change without notice.
• The play time shown depends on operating conditions.
• Mass and dimensions are approximate.
• MB means one million bytes. Useable capacity will be less.
• This product is compatible with the following character code. The display may not
appear correctly with other character codes.
SV-MP100V: 128 MB
SV-MP110V: 256 MB
SV-MP120V: 512 MB
MP332 kHz, 44.1 kHz, and 48 kHz
WMA 8 kHz to 44.1 kHz
MP38 kbps to 320 kbps (128 kbps is recommend)
WMA32 kbps to 192 kbps (96 kbps is recommend)
Stereo, 2 channels (MUSIC, FM RADIO)
Mono, 1 channel (IC RECORDER)
20 Hz to 20,000 Hz (+0 dB, -6 dB) (MUSIC)
300 Hz to 4,300 Hz (
IC RECORDER, HQ mode
)
30 dB (IC RECORDER, HQ mode)
87.90 MHz to 107.90 MHz (200 kHz steps)
87.50 MHz to 108.00 MHz (50/100 kHz steps)
4.5 mW + 4.5 mW (16 Ω, M3 jack)
DC 1.5 V (one alkaline battery)
13 hours (MUSIC)
7 hours (FM RADIO)
13 hours (IC RECORDER, HQ mode)
7 hours (FM RADIO)
53.2 ×61.1 ×17.5 mm
41.7 with battery
30.4 without battery
No operation
No sound or there is a
lot of noise
Play doesn’t resume
from the track where I
stopped play
Play doesn’t start
from the first track
The unit stops working
The display is too dark
or too light
Play doesn't start
immediately
•The HOLD function is on.
•Replace the battery if it is dead.
•Ensure the earphone plug is inserted firmly.
•Wipe the plug clean with a clean cloth.
• Turn up the volume.
•Keep this unit away from mobile telephones.
•This doesn’t work if:
You download, record, delete files, or change
the battery.
The random play mode is on.
•The random play mode may be on.
•Play usually resumes from the track where you
last stopped play. Use skip to return to the first
track.
•Take the battery out for about 5 seconds, then
reinsert it.
•RESET procedure
1. Slide the HOLD switch to ON.
2. Turn the unit on.
3. Press 3 times.
4. Press .
All the memories in the unit are deleted.
•Adjust the contrast. (→page 6)
•Depending on the amount of data in the unit, it
may take some time for play to start after
downloading / recording or changing the battery.
The operation lamp
lights when using a
low-power consumption
display (→below).
Language
ENGLISH
Character code
Unicode
Unicode Big5
Unicode GB2312
Unicode JIS X0208
Unicode CP949
Unicode Windows 1251
Display
ENGLISH
TRADITION
SIMPLE
JAPANESE
KOREAN
RUSSIAN