Panasonic TH-152UX1 important safety instructions Basic Controls

Basic Controls

Remote Control Transmitter

AUTO SETUP button Automatically adjusts the position/size of the screen.

Standby (ON / OFF) button	SLOT buttons
The Plasma Display must first be turned	Press to select SLOT Terminal Board.
on at the power switch (see page 13).	(see page 15)
Press this button to turn the Plasma	PC button
Display On, from Standby mode. Press
	Press to select PC IN input.
it again to turn the Plasma Display Off
	(see page 15)
to Standby mode.
LIGHT button	SDI button, DVI button
The remote control’s buttons illuminate.
HDMI buttons	Press to select SDI IN or DVI-D IN
Press to select HDMI 1 or HDMI 2	input. (see page 15)
input. (see page 15)	SETUP button
PICTURE button	POS. /SIZE button
OK button
Press to make selections.	RETURN button
Cursor buttons	(see page 18)
N button	Press the RETURN button to return
	to previous menu screen.
INPUT button	FUNCTION buttons
Press to select input signal sequentially.	VIDEO MENU button
(see page 15)
	Press to select Picture Mode.
RECALL button	Normal	Dynamic
Press the “RECALL” button to display	Monitor	Cinema
the current system status.

1	Input label	EXIT button
		Exits from Menu screen.
2	Aspect mode
	During 3D images	OFF TIMER button
	Profile name
		The Plasma Display can be preset
	NANODRIFT Saver operating
		to switch to stand-by after a fixed
3	Off timer
		period. The setting changes to 30

The off timer indicator is displayed	minutes, 60 minutes, 90 minutes
only when the off timer has been
	and 0 minutes (off timer cancelled)
set.
	each time the button is pressed.

PC		1
3D	4:3	2
Memory name: MEMORY2
	NANODRIFT
Off timer	90	3

30 60 90

0

When three minutes remain, “Off timer 3” will flash.

The off timer is cancelled if a power interruption occurs.

ASPECT button

Press to adjust the aspect.

Numeric buttons

MEM. LOAD button

17