Connections
When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation.
Speakers (Optional accessories)
| AV | SPEAKERS |
SLOT 1 | SLOT 2PC INSERIAL |
| Terminals (L) | |
SPEAKERS | AC cord connection (see page 12) | |
Terminals (R) | ||
| ||
| – AC cord fixing |
1 |
|
2 | 1 |
| |
| 2 |
1.Open the clamper.
Clamper
2. I n s e r t t h e A C c o r d | 3. Slide up the clamper and fix | 4. Insert the point of the |
and close the clamper | the AC cord plug securely. | fixed clamper into the |
securely. | When loosen | small hole on the lower |
| the clamper: | r i g h t o f |
|
| t h e b a c k |
|
| c o v e r a s |
|
| necessary. |
AC cord |
|
|
Note: The power plug in the illustration may not be the type fitted to your set.
–Cable fixing bands
Secure any excess cables with bands as required.
Pass the attached cable fixing band through the clip as shown in the figure.
To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.
To tighten: | To loosen: |
| |
Pull | Push the catch |
|
1
2 | Pull |
|
|
Optional Terminal Board insert Slots (covered)
R AUDIO L | VIDEO IN | VIDEO OUT | R | AUDIO L | VD HD PR/CR/R PB/CB/B Y/G | AUDIO |
IN |
|
|
| |||
|
|
|
|
| ||
| AV |
| COMPONENT/RGB IN |
| ||
S VIDEO IN |
|
|
| |||
SLOT1 | SLOT2 | PC IN | SERIAL |
|
|
From EXTERNAL monitor terminal on Computer (see page 10)
From SERIAL Terminal on Computer
(see page 11)
9
