Connections
When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation. (Example:
Speakers (Optional accessories)
SPEAKERS
Terminals (L)
SPEAKERS | AC cord connection (see page 13) |
Terminals (R) | |
| – AC cord fixing |
1 |
|
2 | 1 |
| |
| 2 |
Plug the AC cord into the display unit. Plug the AC cord until it clicks.
Note:
Make sure that the AC cord is locked on both the left and right sides.
–Cable fixing bands
Secure any excess cables with bands as required.
Unplug the AC cord
Note:
When disconnecting the AC cord, be absolutely sure to disconnect the AC cord plug at the socket outlet first.
Pass the attached cable fixing band through the clip as shown in the figure.
1
To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.
To tighten: | To loosen: |
| Push the catch |
Pull |
|
2 | Pull |
R AUDIO | L | S VIDEO R | AUDIO | L | VIDEO | R AUDIO L | PR/CR/R PB/CB/B | Y/G |
|
| AUDIO |
B |
| AV IN |
| A |
| COMPONENT/RGB IN |
|
|
| ||
SLOT1 |
| SLOT2 |
|
|
| SLOT3 |
| PC | IN | SERIAL |
| Optional Terminal |
| Dual Video Terminals |
| COMPONENT/RGB IN and |
| Board Insert Slot |
| (equivalent of BNC |
| Audio IN Terminals (equivalent |
| (covered) |
| Dual Video Terminal |
| of BNC Component Video |
|
|
| Board |
| Terminal Board |
Notes: | (see page 12) |
| (see page 12) | ||
|
|
| |||
|
|
|
•At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
•
From EXTERNAL monitor terminal on Computer (see page 10)
From SERIAL Terminal on Computer (see page 11)
9