FAQs

Problem

Actions

 

 

•Set “P-NR” in the Picture Menu (to remove noise). (p. 22)

Chaotic image, noisy•Check nearby electrical products (car, motorcycle, fl uorescent lamp).

Screen

No image can be

•(p.Is “Colour”22)

or “Contrast” in the Picture Menu set to the minimum?

displayed

•Check Colour System. (p. 27)

Blurry or distorted image

•Reset programme. (p. 27)

(no sound or low volume)

•Turn off the TV with Mains power On / Off switch, then turn it On

Unusual image is displayed again.

Sound

No sound is produced

Sound level is low or sound is distorted

Sound is unusual

•Is “Sound mute” active? (p. 9)

•Is the volume set to the minimum?

•Sound signal reception may be deteriorated.

•Set “MPX” (p. 22) in the Sound Menu to “Mono”.

•Set“2chtheL.PCM”.sound setting of the connected equipment to

•Check the “HDMI1 Input” setting in the Sound Menu. (p. 22)

•If digital sound connection has a problem, select analogue sound connection. (p. 42)

HDMI

Pictures from external equipment are unusual when the equipment is connected via HDMI

TV goes into “Standby mode”

Other

The remote control does not work

•Is the HDMI cable connected properly? (p. 40)

•Turn Off the TV and equipment, then turn them On again.

•Check an input signal from the equipment. (p. 44)

•Use an equipment compliant with EIA/CEA-861/861B.

•Off Timer function is activated.

•Theends.TV enters “Standby mode” about 30 mins. after broadcasting

•Are the batteries installed correctly? (p. 6)

•Has the TV been switched On?

46