Panasonic TH-42LF20U, TH-47LF20U DOT, OVER, SCAN, MODE, H-POS, V-POS, CLOCK, PHASE, CLOCK, H-SIZE, V-SIZE, Notes:, Notes:, 1:1 PIXEL, Helpful Hint ( / NORMALIZENormalization)

Adjusting POS. /SIZE

H-POS Adjust the horizontal position. V-POS Adjust the vertical position.

H-SIZE Adjust the horizontal size. V-SIZE Adjust the vertical size.

CLOCK	(During Component, RGB and PC input signal)
PHASE	Eliminate the flickering and distortion.
DOT	(During Component, RGB and PC input signal)
CLOCK	Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,
	adjust so that any such noise is minimized.
OVER	Turn image over scan ON/OFF.
SCAN	Configurable signals are as follows:
	525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, DVI, HDMI)

ONOFF

Notes:

•“OFF” is effective during only “FULL” aspect mode.

•When “OFF” is set, “H-SIZE” and “V-SIZE” cannot be adjusted.

1:1 PIXEL Adjusts the display size when 1125i, 1125p or 1250i signal is input.

MODE

Notes:

•“ON” is effective during only “FULL” aspect mode.

•Select ON when you would like to replay 1920 × 1080 input signal.

•Applicable input signal;

1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p

•Select OFF when flickering is shown around the image.

•H-SIZE and V-SIZE cannot be adjusted when ON is selected.

OFFON

Helpful Hint ( / NORMALIZE Normalization)

While the POS. /SIZE display is active, if either the N button on the remote control is pressed at any time or the ACTION () button is pressed during “NORMALIZE”, then all adjustment values (except “CLOCK PHASE” and “DOT CLOCK”) are returned to the factory settings.

24