Panasonic TH-42PWD3 How to connect the PC Input Terminals, Computer, Rgb, Sda Hd/Sync Scl

Connections

How to connect the PC Input Terminals

COMPUTER

Conversion adapter (if necessary)

RGB

AUDIO

PC IN

D-sub 15p

PC cable

Audio

1/8" (3mm) Stereo Plug

Connect a cable which matches

the audio output terminal on the computer.

Notes:

(1)Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, signals exceeding 1200 lines will not be displayed properly.)

(2)The display resolution is a maximum 640 ⋅ 480 dots when the aspect mode is set to “4:3”, and 852 ⋅ 480 dots when the aspect mode is set to “16:9”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.

(3)The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will need to make setting changes to the computer at the time of connection.

(4)Some PC models cannot be connected to the set.

(5)An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.

(6)There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.

(7)The computer shown in the illustration is for example purposes only.

(8)Additional equipment and cables shown are not supplied with this set.

(9)Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency range.

Signal Names for D-sub 15P Connector

11 12 13 14 15

6 7 8 9 10

1 2 3 4 5

Pin Layout for PC Input Terminal

Pin No. Signal Name

1R

2G

3B

4GND (Ground)

5GND (Ground)

Pin No.	Signal Name	Pin No.
6	GND (Ground)	11
7	GND (Ground)	12
8	GND (Ground)	13
9	NC (not connected)	14
10	GND (Ground)	15

Signal Name

GND (Ground)

SDA

HD/SYNC

VD

SCL

14