Panasonic TH-50PF9UK Connections, Speakers, AC cord fixing, Dvi-D Component/Rgb

Connections

When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation.

Speakers (Optional accessories)

SPEAKERS

Terminals (L)

SPEAKERS	AC cord connection (see page 13)
Terminals (R)
	– AC cord fixing

1
2	1
	2

1. Open the clamper. 2. Insert the AC cord		3. Slide up the clamper and fix	4. Insert the point of the
	and close the clamper	the AC cord plug securely.	fixed clamper into the
	securely.	When loosen	small hole on the lower
		the clamper:	r i g h t	o f
			the back
			cover	as
Clamper			necessary.
	AC cord
Note: The power plug in the illustration may not be the type fitted to your set.

–Cable fixing bands

Secure any excess cables with bands as required.

Pass the attached cable fixing band through the clip as shown in the figure.

1

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

To tighten:	To loosen:
	Push the catch
Pull
2	Pull

	AUDIO	R AUDIO L	PR/CR/R PB/CB/B	Y/G		AUDIO
	DVI-D IN	COMPONENT/RGB IN
SLOT1	SLOT2		SLOT3	PC	IN	SERIAL

Optional Terminal	DVI-D IN	COMPONENT/RGB IN	From EXTERNAL
Board Insert Slot	Terminals	and Audio IN Terminals	monitor terminal on
(covered)	(see page 12)	(see page 12)	Computer (see page 10)

Note:

At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.

From SERIAL Terminal on Computer (see page 11)

9