Panasonic TH-65PF10WK, TH-50PF10WK manual Connections, AC cord fixing, Monitor terminal, See

Connections

TH-50PF10WK

When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation.

Speakers (Optional accessories)

Speaker terminal (L)

Speaker	AC cord connection (see page 13)
terminal (R)
	– AC cord fixing

1
2	1
	2

Plug the AC cord into the display unit.

Plug the AC cord until it clicks.

Note:

Make sure that the AC cord is locked on both the left and right sides.

–Cable fixing bands Secure any excess cables with bands as required.

Unplug the AC cord

Unplug the AC cord pressing the two knobs.

Note:

When disconnecting the AC cord, be absolutely sure to disconnect the AC cord plug at the socket outlet first.

Pass the attached cable fixing band through the clip as shown in the figure.

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

1

2

To tighten:	To loosen:
	Push the catch
Pull

Pull

	R AUDIO	L	PR/CR/R PB/CB/B	Y/G		AUDIO
	COMPONENT/RGB IN
SLOT1	SLOT2		SLOT3	PC	IN	SERIAL

Optional Terminal	Dual HDMI Terminals	COMPONENT/RGB IN and	From EXTERNAL
Board Insert Slot	(equivalent of Dual	Audio IN Terminals (equivalent	monitor terminal
(covered)	HDMITerminal Board	of BNC Component Video	on Computer
	(TY-FB10HMD))	Terminal Board (TY-42TM6A))	(see page 10)
	(see page 12)	(see page 12)

Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.

From SERIAL Terminal on Computer (see page 11)

8