SET UP for Input Signals
COLOR SYSTEM / Panasonic AUTO
Select SIGNAL from the “SET UP” menu during VIDEO (S VIDEO) input signal mode.(“SIGNAL [VIDEO]” menu is displayed.)
Press to select the “COLOR SYSTEM” or “Panasonic AUTO”. |
|
|
|
| |
| SIGNAL | [ VIDEO ] |
| ||
Press to select each function. |
|
|
|
| |
| 3D Y/C FILTER (NTSC) | ON |
| ||
|
|
|
| ||
|
| COLOR SYSTEM | AUTO |
| |
|
|
|
|
| |
If the image becomes unstable: |
| 3 : 2 PULLDOWN | OFF |
| |
|
|
|
|
| |
| Panasonic AUTO (4 : 3) | 4:3 |
|
| |
|
|
|
|
|
|
With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases become unstable. Should this occur, set the system to match the format of the input signal.
Mode |
|
| Function |
|
|
COLOR SYSTEM | Set the color system to match the input signal. When selecting “AUTO”, the color system is automatically | ||||
| selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on | ||||
| the attached terminal board. To display M.NTSC signal, select “M.NTSC” in COLOR SYSTEM. | ||||
| AUTO | PAL | SECAM | M.NTSC | NTSC |
|
| ||||
Panasonic AUTO | Set to “4:3” to view 4:3 images in an unchanged format when Panasonic AUTO is selected. | ||||
(4 : 3 ) | If you would like to view 4:3 images in Just format, set to “JUST”. |
| |||
Note:
Panasonic AUTO does not function when BNC Dual Video Terminal Board
3:2 PULLDOWN
3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as movie pictures, which are recorded at 24 frames per second.
If the picture is not stable, turn the setting to OFF.
Notes:
When ON, this setting only affects the following signal input:
•NTSC / PAL signal input during “VIDEO (S VIDEO)” input signal.
•525i(480i), 625i(575i), 1125(1080)/60i signal input during “COMPONENT” input signal.
Press to select “3:2 PULLDOWN”.
Press to set ON/OFF.
3 : 2 PULLDOWN | OFF |
|
|
XGA MODE
This menu is displayed when the input signal is Analogue (Component/PC). It allows switching between different XGA signal settings for field angle/sampling.
Press to select “XGA MODE”.
Press to select “1024×768”, “1280×768” , “1366×768”.
XGA MODE | 1024 × 768 |
|
|
36
