Panasonic TX-47P500H, TX-47P500X instruction manual Aspect Controls, Auto, Just, Zoom

Aspect Controls

Mode

Picture

Explanation

The AUTO position can be set to 4:3 or to

JUST. When a wide screen signal is

AUTO

detected at the Video terminal the TV will

select the 16:9 aspect ratio.

4 : 3

JUST

4 : 3

JUST

Red

4 : 3

Select

4 : 3

mode

16:9 Signal

4:3 Signal

Green

JUST

Select

JUST

mode

This option will display a standard 4:3

4 : 3

picture

without

any

stretching or

compression. There will be vertical gray

lines down either side of the picture.

This option allows you to magnify or reduce

part of the picture.

ZOOM

ZOOM

Red

V SIZE - Reduce the picture

Green

V SIZE + Magnify the picture

Yellow

V POS - Move picture Down

V SIZE—

V SIZE+

V POS—

V POS+

Blue

V POS + Move picture Up

S-Zoom displays part of the picture at a

greater magnification than the Zoom mode

does. The coloured buttons let you change

S-ZOOM

S-ZOOM

the position of the magnified area.

Red

H POS - Move picture Left

Green

H POS + Move picture Right

H POS—

H POS+

V POS—

V POS+

Yellow

V POS - Move picture Down

Blue

V POS + Move picture Up

The 16:9 option will display the picture at

its maximum size. Signals in the 4:3 format

16 : 9

will be stretched to fit the picture.

16:9 Signal

4:3 Signal

The 14:9 option will display a 4:3 signal in

simulated wide screen. The picture is

14 : 9

14 : 9

slightly stretched. It is also slightly cropped

top and bottom.

(Australia and

The colour buttons let you change the

New Zealand only)

V POS—

V POS+

position of the stretched area.

Yellow

V POS - Move picture Down

Blue

V POS + Move picture Up

JUST gives you a

best fit option when

JUST

showing 4:3 on wide screen. The centre of

the picture is not affected but there is some

stretching at the edges.

Note:

ASPECT operations cannot be made during progressive (Y, PB, PR) or 1080i signal input.

33