Screen
Sound
HDMI
Other
Problem | Actions | |
Chaotic image, noisy | tSet | |
| tCheck nearby electrical products (car, motorcycle, fluorescent lamp). | |
No image can be displayed | tIs [Contrast], [Brightness] or [Colour] in the Picture Menu set to the minimum? | |
| (p. 27) |
|
|
|
|
Blurry or distorted image | tReset channels. (p. 34, 35) |
|
(no sound or low volume) |
| |
|
| |
Unusual image is displayed | tTurn the TV Off with Mains power On / Off switch, then turn it On again. | |
| tIf the problem persists, initialise all settings | [Shipping Condition] (p. 47) |
No sound is produced | tIs “Sound mute” active? (p. 8) |
|
| tIs the volume set to the minimum? |
|
Sound level is low or sound | tSound signal reception may be deteriorated. |
|
is distorted | tSet [MPX] (p. 29) in the Sound Menu to [Mono]. (Analogue only) | |
| tSet the sound setting of the connected equipment to “2ch L.PCM”. | |
Sound is unusual | tCheck the [HDMI1 / 2 Input] setting in the Sound Menu. (p. 30) | |
| tIf digital sound connection has a problem, select analogue sound connection. | |
| (p. 70) |
|
|
|
|
Pictures from external | tCheck the HDMI cable is connected properly. | (p. 66) |
equipment are unusual | tTurn the TV and equipment Off, then turn them On again. | |
when the equipment is | tCheck an input signal from the equipment. | (p. 71) |
connected via HDMI | tUse equipment compliant with | |
The TV does not switch On | tCheck the mains lead is plugged into the socket outlet. | |
The TV goes into Standby | tAuto power standby function is activated. | (p. 9) |
mode | tThe TV enters Standby mode about 30 minutes after analogue broadcasting ends. | |
| tAre the batteries installed correctly? (p. 6) |
|
| tHas the TV been switched On? |
|
The remote control does not | tThe batteries may be running low. Replace them. | |
work or is intermittent | tPoint the remote control directly at the front of the TV (within about 7 m and a 30 | |
| degree angle of the front of the TV). |
|
| tSituate the TV away from sunshine or other sources of bright light not to shine on | |
| the TV’s remote control signal receiver. |
|
|
| |
Parts of the TV become hot | tEven when the temperature of parts of the front, top and rear panels has risen, these | |
| temperature rises will not pose any problems in terms of performance or quality. | |
The LCD panel moves | tThere is some flexibility around the panel to prevent damage to the panel. | |
slightly when it is pushed | ||
with a finger | tThe panel might move slightly when it is pushed with a finger, and clattered sound | |
Clattered sound might be | might be heard. This is not a malfunction. |
|
heard |
|
|
|
|
|
| tFollow the message’s instructions. |
|
An error message appears | tIf the problem persists, contact your local Panasonic dealer or the authorized Service | |
| Centre. |
|
|
|
|
Frequently Asked Questions
73
