Panasonic TX-L37U3E Set DVB channel manually Manual Tuning, Reduce the DVB-C signal Attenuator

Press OK to update channel list.

Press EXIT to ignore.

Check DVB signal [Signal Condition]

Selects a channel and checks the DVB signal condition.

A good Signal Strength is not an indication of suitable signal for DVB reception. Please use the Signal Quality indicator as follows :

[Signal Quality] : t
Green bar Good t
Yellow bar Poor

t
Red bar Bad (Check the Terrestrial aerial or cable)

DVB-C Signal Condition

New channels found!

Set DVB channel manually [Manual Tuning]

Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.

If tuning has not been done completely or for adjusting the direction of the aerial, use this function. t
All channels found will be added to the Channel List.

DVB-C :
1 Enter the frequency	2 Search

DVB-C Manual Tuning

abc def

Frequency		474,00 MHz					ghi	jkl	mno
Symbol Rate		Auto					pqrs	tuv	wxyz
Service ID		Auto
Signal Quality					100	%	t Normally set [Symbol Rate] and [Service
Signal Strength						%
					100
No.	Channel Name		Type	New
							ID] to [Auto].
Free TV: 0	Pay TV: 0	Radio: 0
	Stopped

DVB-T :

1 Adjust frequency for each channel

DVB-T Manual Tuning

Frequency		[CH21]		474,00 MHz
Signal Quality				100%
Signal Strength				100%
No.	Channel Name		Type	New
Free TV: 0	Pay TV: 0	Radio: 0		Data: 0
		Stopped

2 Search

select channel

adjust frequency

t
Set where the level of [Signal Quality] becomes the maximum.

Tuning and Editing Channels (DVB)

Update DVB channel automatically [Update Channel List]

You can add new channels, delete removed channels, update channel name and position automatically to Channel List.

DVB-T Update Channel List				Channel List is updated while keeping your settings in [Favourites Edit],
Progress	CH 5		69	t
				[Channel List], [Child Lock], etc.
This will take about 3 minutes.				t Depending on the signal condition, the update may not work properly.
CH	Channel Name	Type	Quality
Free TV: 0	Pay TV: 0	Radio: 0
	Searching

Display a notification message [New Channel Message]

Selects whether to give a notification message when a new DVB channel is found. [Off] / [On] t
Selecting OK will perform [Update Channel List].

t
To change the channel

Channel Name	70 CBBC Channel
Signal Quality		90%	These bars show the maximum signal value of the selected channel.
Signal Strength		80%
Bit Error Rate	0.00E+00
Network Name	Wenvoe
Parameter	802,00 MHz, 64 QAM, 6940 kS/s

Reduce the DVB-C signal [Attenuator]

If the DVB-C signal is too strong, the interference may occur. In this case set to [On] to reduce the signal automatically. t
This function is available only for DVB-C signal.

38