Supplying Power
Charging the Battery Pack | 1 Plug in AC Adaptor. | ||
Charge Battery Pack fully before use. | |||
|
|
| POWER Lamp lights. |
| 2 | 3 | 2 Insert Battery. |
|
| A Align left side of Battery with left edge of | |
|
|
| AC Adaptor. |
|
|
| B Press Battery down and slide in direction |
POWER |
| 1 | of arrow. |
| The CHARGE Lamp flashes, then stays lit | ||
Lamp |
| ||
| when charging is complete. | ||
|
|
| 3 Remove Battery. |
|
|
| Slide Battery to the left and lift off. |
CHARGE |
|
| Note: |
Lamp |
|
| • Charging takes about 1 hour. |
|
|
| • While the DC Power Cable (supplied) is connected |
| A |
| to the AC Adaptor, the Battery cannot be charged. |
| B | • After charging 5 times, use Battery Refresh feature | |
|
| as explained below. | |
•Battery life gradually decreases after repeated use
and recharging. If operation time becomes very
(Top View)short even after a sufficient charge, discard Battery properly (pages 9, 34).
Using the Battery Pack
A fully charged Battery provides a maximum of about 1 hour 10 minutes of continuous use (LCD monitor off) or about 55 minutes (LCD monitor on). Actual time may vary due to operating conditions. Using the
a
A b
B
Battery Refresh
This feature completely discharges Battery before recharging begins. Use after every 5 charges for optimum Battery performance.
REFRESH
Lamp
BATTERY
REFRESH
ALift up EVF and attach Battery.
aInsert top of Battery into top of mounting surface.
bPress and snap into place.
BRemove Battery.
Slide BATTERY RELEASE and remove Battery.
To use battery refresh, insert Battery on AC Adaptor (see steps 1~2 above), then press
BATTERY REFRESH.
The REFRESH Lamp lights, then goes out when discharge is complete. Battery charging will then start automatically.
If BATTERY REFRESH is pressed by mistake, remove Battery from AC Adaptor and reinsert it for normal charging.
Note:
•Charging takes about 5 hours when Battery Refresh is used.
•Battery will not operate in extremely high temperatures.
8
For assistance, please call :
