Pantel PAN420, PAN520 Setup Menus, ~4 STV-1100TX Transmitter Unit Connect power cord, Power On

Models: PAN520 PAN200 PAN420 PAN320 PAN650

1 30
Download 30 pages 200 b
Page 25
Image 25

 

 

 

‹

Power Switch

Press the power button to turn the power ON/OFF

 

 

 

‹

DC IN

Connect the DC-in from the supplied AC adaptor here

 

 

 

‹

S-VIDEO IN

Connect the S-Video cable here if the input source - DVD, VTR

 

 

etc has an S-Video out.

 

 

 

‹

S-VIDEO OUT

This is a through signal of the S-Video IN

 

 

 

‹

Audio OUT

This is a through signal of the Audio IN

 

 

 

‹

Video OUT

This is a through signal of the Composite Video IN

 

 

 

‹

Audio In

Connect the Input source Audio in using supplied AV cable

 

 

 

‹

Video In

Connect the Input source Video in using supplied AV cable

 

 

 

‹

IR Connector

If remote control is required connect the supplied IR cable here.

 

 

 

‹

Pairing SW

Pairing setup (see later instructions)

 

 

 

NOTE: The IR function enables the user to control the DVD (or other video source) even when the TV and the DVD are not in the same room. The user can use the DVD’s remote control unit by pointing the remote control at the IR receiver located at the VW-5RX. The IR signals are conveyed by wireless signal to the VW-5TX.

Chapter 2 Setup Menus

The following lists a step by step set-up procedure.

Step 1~4 STV-1100TX Transmitter Unit

Step 1 Connect power cord

Connect power cord to AC adaptor.

Attach AC adaptor to DC IN jack on VW-5TX unit.

Step 2 Power On

Press the power button on the rear to turn the power ON.

Step 3 Connect video sources

Connect your Video device (DVD, VAR, PVR, STB or BS) using the supplied S-Video or AV video cable

Step 4 Video Input

Connect AV cable to video input jack and/or connect S-Video cable to S-Video IN jack on the VW-5TX unit. If both signals are available the S-Video will be the priority and used due to its higher quality.

IR Function

If you require use of a remote control connect the included IR cable at the back of the VW-5TX unit. Then locate the LED head module of the cable in front of the usual IR receive point of the input source (e.g. DVD player, cable box)

25/30

Page 25
Image 25
Pantel PAN420 Setup Menus, ~4 STV-1100TX Transmitter Unit Connect power cord, Power On, Connect video sources, Video Input