093 BODYSM]~THPROSYSTEiV~ ASSE1V~BLY INSTRUCTIONS
[NIP. ORTANT.:
¯TIlE BODYSMITH PROSYSTEM MUST BE ASSEMBLED ON A FLAT LEVEL SURFACE TO ASSURE ITS PROPER FUNCTION.
¯PARABODY, INC. STRONGLY RECOMMENDS THAT THIS PRODUCT BE ~SSEMBLED .BY TWO PERSONS TO AVOID POSSIBLE INJURY.
I~.EP ALL LOOSE FRAME
-CONNECTIONS
LOOSE UNTIL ~NSTRUCTED IN THE ASSEN[BLY STEP SEQUENCES TO ,,SECURELY TIGHTEN
1.Insert six (6) 2 IN. SQ. ENDCAPinto both FRONTUPRIGHTSTwo.(2) into each end of the LEG, and one (I) into the TOPend of the UPRIGHT.
LOOSELYassemble the BOTTOMUPRIGHTSUPPORTto both
NUTS. (NOTE: THE LOW ROW BAR IIOLDERS ON THE BOTTOM UPRIGHT SUPPORT SHOULD BE UNDERNEATH) (SEE DR.AWING)
LOOSELYassemblethe TOP UPRIGHTSUPPORTto both FRONTUPRIGHTS,usingtwo (2) 3/g
3IN.BOLTS,four(4)3/8IN.WASHERS,two (2)3/8IN.LOCKWASHERS,andtwo(2)318IN.
(NOTE: MAKE SURE THAT THE TOP UPRIGHT SUPPORT IS FLUSH WITH THE TOP OF THE FRONT UPRIGHT) (SEE DRAWING)
LOOSELY assemble the MAIN UPRIGHT to the TOP and BOTTOM UPRIGHT SUPPORT, using
four (4) 3/8 X 3 IN. BOLTS,eight (8) 3/8 IN. WASHERS,four (4) 3/8 IN. LOCKWASHERS,and
(4) 3/8 IN. NUTS. (SEE DRAWING)
A~ach eight (8) CARRIAGEGUIDESto the WEIGHTCARRIAGEas shown in (DETAIL D) using following steps:
A.Thoroughlyclean all inside surfaces xvherc the CARR.IAGEGUIDESare to be attached.
BoRemovethe paper backing from the CARRIAGEGUIDESand firmly apply them to all Shown surfaces (8 places)
