Step 7
A.Loosely aftachthe pressarm odiu.s,, ~ (23) to the rear up.r,!gh~(21) using two 1" pillow block bearings (112), four 3/8 x
B.
Center press arm adiust (23) to I~ne up w~th ~he post on the press base (13) and securely ~ighlen set screws on the pillow block bearings (112).
C.
Adiusl pillow block bearings (112) until the press arm ad[us~ (23) is level and securely tighten
bolls.
D.Securely assemble one 1/2" spring pln (64) to the press arm (6) as shown.
s~u~=.=~ ~e p~e.. ~=~) ~o ~.~ p~'" =~= ~iu~ (~) "'~ o~ ~/~ ~
~wo 1/2" washers (79), ~wo 1 flange bearings (69), a,nd one 1/2" low height nylock (Note: Securely tighten, then back nut off 1/4 turn to allow the press arm to rofcffe freely.)
r. s~u~.~y=,~h~,~/~o~ro~(7) ~o~h~p~.,, b=~(~3) u,~ng~o~/2 ~ ~" bo~,(~8), four~o the
/z" low height nylock nuts (84). Apply ~wo
washers (79), and two calf / low row a~s shown.
G.AHach swivel pulley bracket (41) fo the press base (13) using one 1/2" low height nylock
(84). (Note: Securely tighten, ~hen back nu~ off 1/4 turn fo allow the swivel pulley bracket fo rotate freely.)
11
