ParaBody ex 350 Function, Contact Your Dealer or Your Parabody Customer Service, Vel, Tighten

358 EX350 A:~SEtvlBLY INSTRUCTIONS

,THANK YOU	.;
: "	" : ~2..-~.-_:.
.	.."....~---~..

FOR PURCHASING THE ~ PLEASE SAVE THESE ASSEMBLY INSTRUCTIONs

FOR YOUR PERSONAL REFERENCE, AND ADDITIONAL SERVICE INFORMATION.,~,~"

. ¯

***IMPORTANT***

"::

THE EX350 MUST BE ASSEMBLEDON A FLair, LEVEL SURFACE TO ASSURE ITS:''"~

FUNCTION.

PARABODY INC. STRONGLY RECOMMENDSTHAT THIS PRODUCT BE ASsEMBI~ED.

PERSONS TO AVOID POSSIBLE INJURY.

KEEP ALL FRAME CONNECTIONS LOOSE, UNTIL INSTRUCTED IN THE ASSEMI

SEQUENCES TO SECURELY TIGHTEN. ""

¯IF YOU EXPERIENCE ANY PROBLEMWITFL T,'HE ASSEMBLYOFTHIS PRODUC'-r,

CONTACT YOUR DEALER OR YOUR PARABODY CUSTOMER SERVICE

¯TOOLS REQUIRED:RATCHET, 3/4 SOC ..K~or WKENCH, 9/16 SOCKETor.WRt"" ADJUSTABLE WRENCH. $/32 ALLEN WRENCH, and RUBBER MALL~'T or HAMMER";

*** REFER TO ASSEMBLYDRAWING#1 FOR STEPS 1THRU 13 ***

Bolt HEADXVEIGHTPLATEinto the threaded hole at top of SELECTCENTERSHAF'T, using one

(I } 3 ~ X I-1 2 IN. FlEX FlEADBOLT.one (l) 3.'8 IN. LOCKWASHER,and one (l) 3.'8 IN. WASHER (SEE DETAIL DL

Put seven t7} 2 IN. SO. END.CAPS into ends of tubes on WEIGHTSTACKSUPPORTBASE.

Attach one t I} 4-I 20.D. DIA. PULLEYwith 1 IN. BUSHINGto WEIGHTSTACKSUPPORTBASE using one ( I } ~ $ X 2 IN. HEXHEADBOLTone. ( ! ) CABLERETAINING"L" CLIP. a'.ad one (I) 3/8 IN.

LOCKNUT. (DO NOT TIGHTEN)

Insert t~o {2~ I 2 IN. FLANGEBEARINGSinto tube on LOWROWSWIVELBRACKET_.

Attach LOWROWSWIVEL BRACKETto YOKE on WEIGHTSTACK SUPPORT BASE, using one { 1 } ! 2 X4 IN. I IEXHEADBOLTand. one (!) 1.'2 IN. LOCKNUT.Tighten so it swivels freely, yet

doesn't ~vo.bble.		~
LOOSELYattach'one I I ~	.,t-l" O.D'.'DII-X.	il	.	)	VEL
BRACKETusin~. one ~ I ~ 3 ,~	X 2 IN. HEXHEADBOLTand one t		I ~ 3 8 IN. LOCKNU'['(DO. NOT
TIGHTEN}