ParaBody ex 350 manual Referto ASSEMBLYDRAWING#4 for Steps 45 THRU58, Bearing Housing

358 EX350 ASSEMBLY INSTRUCTIONS

44.¯

¯

PuII.CABLE up to the PULLEYin the PULLEYHOUSINGabove the WEIGHTSTACKon the MAINUPRIGHTTOP SECTION. Pull CABLEover and down PULLEYand thru hole in MAIN UPRIGHT TOP SECTION to SELECT CENTER SHAFT on HEAD WEIGHT PLATE. (REMOVE PULLEY FOR EASE OF INSTALLATION)

Attach the PRIMARYCABLEto the HEADWEIGHTPLATE ASSEMBLYb. .v threading the STUD into .the SELECT CENTER SHAFT and TIGHTEN COMPLETELY.

To install the SECONDARYCABLEstart. by inserting the end of'the CABLEinto the front of the

LOW ROW SWIVEL BRACKET. (REMOVE.PULLEY FOR EASE OF INSTALLATION)

Pull the CABLEupward behind the PULLEYuntil the WHITEBALLstops at the frdnt of the LOW ROW SWD,'EL BRACKET.

Run CABLEaround the BOTTOMPULLEYof:the (SUSPENDED) PULLEY/PLATE CONNECTOR ASSEMBLY.

Pull CABLEunder PULLEYon WEIGHTSTACKSUPPORTBASE tow'ards fro~t of bIACHINE.

(NOTE: BE SURE TO PLACE CABLE RETAINING "L" CLIP UNDER PULLEY AFTERWARDS)

To finish SECONDARYCABLE INSTALLATION. run CABLE under PULLEYon the PULLEY BRACKETof the LEG CURL EXTENSION,~Rbl. (REMOVE PULLEY FOR I.'ASE OF INSTALLATION)

*** REFERTO ASSEMBLYDRAWING#4 FOR STEPS "45 THRU58 ***

LOOSELYassemble two 12) 4-I ~ DIA. PULLEYSwithI IN. BUSHING.to the PULLEYBILA, CKET SUPPORTas shown, using two (2I 3 8 X 2 IN. HEXHEADBOLTS. t~vo (2) CABLERETAINING

CLIPS and two ~2~ 3 8 IN. LOCKNUTS(NOTE:. DO NOTTIGHTEN)

Insert four (4) "~ 4 IN. FLANGEBEARINGSinto the TOPand BOTTOMends of the BI[JSHINGSin the

BEARING HOUSING.

47.lnsert'fbur {4) 2 IN. SQ. ENDCAPSinto open ends of'LEFT and RIGHTPEC DECARMS.

48.Insert PIVOTof each ARMinto FLANGEBEARINGSin the BEARINGHOUSINGa~ad secure with two {2~ STAR LOCKCOLLARS.

49.Peel offbacking fi-om t~o (2} 1 IN. SQ. PLASTICSTOPS. attach to ANGLEIRON'STOPBRACKET on. BEARINGHOUSINGwhere ARMCAMSmake contact.

50.Slide LARGEFOAMROLLERPADSonto LEFT and RIGHT PEC DEC ARblS. (NOTE'." IF LUBRICANT IS REQUIRED, PARABODY RECOMMENDS THOROUGHLY COATING THE INSIDE OF THE GRIP WITH RUBBING .ALCOHOL)

52.SECURELVassemble the SEAT PAD to MAINUPRIGHTBOTTOMSECTIONusilag two (2) 3/8 2-3 4 IN. HEXHEADBOLTSand two t2) 3/8 IN. LOCKWASHERS.

9