BRACKET INSTALLATION FOR MILLENIA™ 20 AND MILLENIA™ 30 (Figs. 9a – 9e)
IMPORTANT: Please read before installing brackets
Paradigm DOES NOT supply hardware for mounting brackets to the wall. Mounting hardware shown is an example only; hardware will vary depending on wall type.
Install into 1/2˝ (13 mm) or 5/8˝ (16 mm) drywall only. Screws must be long enough to go through anchor bolts and firmly into drywall (see inset circle, below).
BRACKET PARTS LIST (per speaker):
• 1 –
PARTS REQUIRED, NOT INCLUDED (per speaker):
• 4 – Anchor bolts (minimum load rate 25 lb / 11.3 kg) • 4 – Flathead (Countersunk) screws
Fig. 9a
NOTE: This step is for positioning only. Screws will be removed in next step to allow installation of additional bolts.
Position bracket and ensure it is level. Mark the two inner screw holes. Drill pilot holes, then press anchor bolts firmly into drywall and screw in. Follow with flathead screws: DO NOT SCREW ALL THE WAY IN AT THIS POINT
Fig. 9b
Bracket is slotted (see illustration), to allow further adjustment left or right, if necessary.
Fig. 9c
Remove the two flathead screws (not shown). Drill outer pilot holes, then press anchor bolts firmly into drywall and screw in. Now insert all four flathead screws and tighten.
WARNING! For stability, all four flathead screws MUST be used.
WARNING! All screws must be inserted straight and fully tightened to ensure correct operation of anchor bolts.
5