Fig. 9d (Before wiring speakers see note on Fig. 9d – 1 and Fig. 9d – 2 below)
CONNECTING SPEAKER
Pull cables through center hole in bracket and connect speaker following the information on Page 10.
ADJUSTING THE SPEAKER’S ANGLE OF TILT
The
•To further optimize imaging, you can tilt Left and Right speakers inward 7° (Fig. 9d – 1) positioning the
•To further optimize clarity and intelligibility, you can tilt the center speaker up 7° or down 7° (Fig. 9d – 2) positioning the bumper pads marked 7° (as shown).
•You can also mount the speakers parallel to the wall (Fig. 9d – 3) positioning the
Adjustments should be done before mounting speakers to the wall:
Horizontal Position |
Adjusting Tilt on Left / Right Speakers
LEFT SPEAKER | RIGHT SPEAKER |
Rotate speaker before wiring!
Fig. 9d – 1
The above image shows top view looking toward listening area. Pads must sit at edges closest to
LEFT SPEAKER: To tilt speaker inward, rotate speaker 180° then attach the pads marked 7° (as shown).
RIGHT SPEAKER: To tilt speaker inward, simply attach the pads marked 7° (as shown).
Adjusting Tilt on Center Speaker
CENTER SPEAKER
Tilted down
Tilted up.
Rotate speaker before wiring!
Fig. 9d – 2
CENTER SPEAKER: (shown in side view) To tilt speaker down, attach pads marked 7° (as shown). To tilt speaker up, rotate speaker 180° then attach pads marked 7° (as shown).
Mounting Speakers Parallel to Wall
ALL SPEAKERS
Fig. 9d – 3
To mount all speakers parallel to wall, attach pads marked 0° (as shown).
POSITIONING BUMPER PADS
Perspective in images shows only one pad. Two pads are required, positioned as shown on the lower recessed areas (shaded areas) of the keyhole slot sections (see Inset below).
Horizontal Position |
Fig. 9e
Align keyhole slots (shown at right) on rear of speaker with pro- truding screw heads on bracket, then using an
keyhole slots
6
