Paradyne 3980-A2-GZ40-20 Table 3 AT Commands for SDC AT Command Description DCP LCD, Command Sequence

9
3980-A2-GZ40-20 November 1996
Table 3
AT Commands for SDC
AT
Command Description DCP LCD
Command
Sequence
#DM n SDC Delay Minimization.
Minimizes the delay introduced by SDC by allowing the modem to transmit a
DTE frame to its DTE in a discontinuous way.
#DM0 No delay minimization. The modem does not begin transmitting a
frame to its DTE until the entire frame has been received.
#DM1 Delay minimization. The modem begins to transmit data from a
DTE frame to its DTE even if the end of the DTE frame has not yet
been received by the modem.
The factory setting is No Delay Minimization.
Configure\Edit\
V42/MNP/Buffer
#Q n Sync Flow Ctrl. Synchronous Flow Control of DTE.
Controls the type of synchronous data flow control while using data
compression.
#Q0 No flow control.
#Q1 Flow control using transmit clock (circuit 114).
#Q2 Flow control using CTS (circuit 106).
The factory setting is No Flow Control.
Configure\Edit\
V42/MNP/Buffer
#SC n Sync Comp Mode. Synchronous Compression Mode.
Enables and disables synchronous data compression.
#SC0 Disable Synchronous Data Compression mode.
#SC1 Enable Synchronous Data Compression mode.
The factory setting is Disable.
Configure\Edit\
V42/MNP/Buffer