8CONNECTING THE A 52 TO TRIGGER ANOTHER COMPONENT
Whenever the A 52 is turned on either manually or automatically, there is 12 Vdc present at its own DC Trigger Out jack so it can trigger additional amplifiers or other components on and off.
2.5 mm
What You’ll Need:
•A wire with a 2.5 mm
•A component that can be triggered with an external +9 Vdc to +12 Vdc source. The A 52 DC trigger output provides up to 150 mA of current
Before Connecting
❑Remove power to all the components in your audio system.
To Connect
1Plug one end of the trigger wire into the 12V Output jack on the A 52.
2Plug the other end of this wire into the component that you want the A 52 to trigger.
2
Input
CONTROLLED
COMPONENT
| Auto Turn On Switch, |
1 | set to down position |
Parasound Products, Inc.
San Francisco, CA USA
L U C A S F I L M
Manufactured under license from Lucasfilm Ltd. Lucasfilm and THX are registered Trademarks of Lucasfilm Ltd.
CAUTION
To Prevent Electric Shock, Do Not
Remove Cover. No
Parts Inside, Refer Servicing To
Qualified Service Personnel.
Ch 1 | Ch 2 | Ch 3 | Ch 4 | Ch 5 |
Balanced | Balanced | Balanced | Balanced | Balanced |
Input | Input | Input | Input | Input |
Unbalanced | Unbalanced | Unbalanced | Unbalanced | Unbalanced |
Balanced |
| Audio | Sensitivity | Lift |
|
|
| 50 mV 250 |
|
|
| Man |
|
|
Unbalanced Output | Input | 12 V |
| Normal |
Inputs |
|
|
| Ground |
| Auto Turn On |
|
| |
|
| WARNING |
| |
| To Prevent Fire Or Shock Hazard, |
| ||
| Do Not Expose This Unit To Rain |
| ||
|
| Or Moisture. |
| |
|
| Fuse |
|
|
|
| |||
|
|
| ||
|
| AC 115V | 60Hz |
|
|
| AC 230V | 50Hz |
|
Power Consumption: 1350W
YOU SHOULD KNOW
If the device you want your A 52 to control doesn’t have a 2.5 mm trigger output connector, you can cut one plug off the cable and terminate the end as required. The lead with the stripe is positive and the lead without the stripe is negative.
