CONNECTING AN EXTERNAL DC SOURCE FOR
AUTOMATIC TURN ON-OFF
7
To automatically turn on and off the A 52 with an external DC voltage, choose the DC Triggering option by moving the Auto Turn On switch on the rear panel to its lower 12V position.
2.5 mm
What You’ll Need:
•A cable with a 2.5 mm
•A “control” component with +9Vdc to +12Vdc trigger voltage
Before Connecting
❑Remove Power to all the components in your audio system.
❑Make sure the Auto Turn On switch on the A 52 rear panel is in its 12V (down) position.
To Connect
1Plug one end of the trigger wire into the 12V Input jack on the A 52.
2Plug the other end of this wire into the external DC source.
2
Output
CONTROL
COMPONENT
Audio Turn On Switch,
1set to down position
Parasound Products, Inc.
San Francisco, CA USA
L U C A S F I L M
Manufactured under license from Lucasfilm Ltd. Lucasfilm and THX are registered Trademarks of Lucasfilm Ltd.
CAUTION
To Prevent Electric Shock, Do Not
Remove Cover. No
Parts Inside, Refer Servicing To
Qualified Service Personnel.
Ch 1 | Ch 2 | Ch 3 | Ch 4 | Ch 5 |
Balanced | Balanced | Balanced | Balanced | Balanced |
Input | Input | Input | Input | Input |
Unbalanced | Unbalanced | Unbalanced | Unbalanced | Unbalanced |
Balanced |
| Audio | Sensitivity | Lift |
|
|
| 50 mV 250 |
|
|
| Man |
|
|
Unbalanced Output | Input | 12 V |
| Normal |
Inputs |
|
|
| Ground |
| Auto Turn On |
|
| |
|
| WARNING |
| |
| To Prevent Fire Or Shock Hazard, |
| ||
| Do Not Expose This Unit To Rain |
| ||
|
| Or Moisture. |
| |
|
| Fuse |
|
|
|
| |||
|
|
| ||
|
| AC 115V | 60Hz |
|
|
| AC 230V | 50Hz |
|
Power Consumption: 1350W
YOU SHOULD KNOW
If the device you want to use to control your A 52 doesn’t have a 2.5 mm trigger output connector, you can cut one plug off the cable and terminate the end as required. The lead with the red stripe is positive and the lead without the stripe is negative.
