Parasound Zamp v.2 owner manual Introduction, Unpacking

Introduction

Congratulations and thank you for your purchase of this precision Parasound audio component. The Parasound Zamp v.2 is designed for a wide variety of applications, including multi-room, multi-zone installations, desktop audio, bedroom or den systems. The incredible versatility of the Zamp v.2 allows many connection and configuration options, so please be sure to read this manual thoroughly before you begin installation.

Unpacking

Carefully unpack your Zamp v.2, remove the enclosed AC power cord and the sub-mini

2.5mm trigger connection plug and wire. Be sure to inspect the unit for any possible shipping damage. If you notice any, contact your Parasound Dealer immediately. Save the carton and all of the packing materials in case you ever need to ship your amplifier for repair. Before you proceed, locate the serial number on the rear panel or underside of the unit and record it here for future reference:

Serial #_____________________________	Purchase Date _____________________
Parasound Dealer ____________________	Phone Number _____________________

Installation and Rack Mounting

Install your Zamp v.2 away from heat sources such as heating ducts and radiators. Always mount the amplifier horizontally.

Its panel dimensions are one rack space high (1 3/4" or 44 mm) by one-half rack space wide (9 1/2" or 242 mm). It will fit into a standard 19" wide equipment rack when mounted side-by-side with other Parasound half-width components. Optional accessory parts are available from Parasound to rack mount the Zamp v.2 by itself or alongside another Parasound half width unit.

Ventilation Requirements

The Zamp v.2 can generate substantial heat and requires adequate ventilation to prevent overheating and shut down by its thermal protection circuit. Observe the following ventilation guidelines when installing the Zamp v.2 in a cabinet or other enclosed area:

1)If you are not using a ventilation fan, allow few inches on each side and above the unit. You should never install the Zamp v.2 in an unventilated equipment cabinet with a door or panel because hot air cannot exhaust adequately.

3)Do not place the Zamp v.2 on carpeting or any other material that could obstruct airflow through the ventilation holes in the bottom of its chassis.

4)Try to avoid stacking the Zamp v.2 tightly between other components because the heat it produces will not dissipate adequately and may cause overheating of the amplifier and the other units.

5