115

Voltage Selection Switch for the Zamp v.2

The Zamp v.2 can be easily converted for 110-120 Vac or 220-240 V operation by using the voltage selector switch located on the bottom of the unit.

For 110-120 Vac operation. Slide the switch into the position until the section of switch labeled "115" appears through the opening in the chassis.

For 220-240 Vac operation. Slide the switch into the position until the section of switch labeled "230" appears through the opening in the chassis.

230

Image 11

Contents

Zamp v.2 Zone Amplifier Table of Contents Important Safety Instructions Zamp v.2 Front and Rear Panel Unpacking Looping Output Connections Connection PrecautionsStereo Mono Switch Input Connections Trigger Input Connection Configuring the Zamp v.2 for Mono operationAuto On Select Switch Front Panel Indicators AC Line Audio Trigger Sensitivity AdjustmentGround Lift Switch AC Power Connections and AC Grounding If All Else Fails Main Power FuseHeadphone Jack Parasound Staff Returning your Zamp to Parasound for ServiceImportant Notice before Shipping your Zamp Finally 115 Slew Rate Continuous Power Output MonoWeight Current Capacity Parasound Products, Inc. Rev

Parasound Zamp v.2 owner manual 115