Parker Hannifin Karrykrimp 2 technical manual Parkalign Feature

Bulletin 4480-T7-US	Karrykrimp 2
Crimping Instructions
Crimping Instructions for 26, 43, 70, 71, 73, 78 and 81 Series Fittings

1.The Hose Insertion Depth fixture can be used to mark the insertion depth on the hose.

2.Push the hose all the way into the coupling to the insertion depth mark. Do not use lubricant to assemble spiral hose and fittings.

3.Remove pin from inside pusher unit so pusher will swing back. Lubricate the die bowl cavity to prevent wear.

PARKALIGN® Feature





4. Place unitized die-train in bowl. See decal on crimper for proper die set.

Note: Die sets are color coded by size.

7.Place the die ring on top of the dies. See decal on crimper for proper die ring; Silver and Black.

5.Position the hose and fitting in dies from below.

8.Reposition pusher, replace pin, operate pump until ring bottoms out on base plate.

6.Rest bottom of coupling on die step using PARKALIGN® feature.

9.Release pump pressure and remove finished assembly.

Note: See Hose Insertion Depth table at the right.

Important: Hose assemblies must be inspected for cleanliness and free of all foreign particles.

Note: Parker Hannifin will not accept responsibility for the operations of, or provide warranty coverage for, a crimper that is operated by a power unit other than equipment supplied by Parker Hannifin for the expressed purpose of operating the designated crimper.

Hose Insertion Depth
Hose by			Fitting Series
Dash Size	26	43	70	71	73/78	81
-4	13/16”	13/16”
-5	13/16”	15/16”
-6	13/16”	1-1/8”	1-1/16”	1-1/16”
-8	13/16”	1-5/16”	1-5/16”	1-1/4”
-10	7/8”	1-9/16”	1-3/8”	1-5/16”
-12	7/8”	1-1/2”	1-1/2”	1-7/16”	1-7/8”	1-1/8”
-16	1”	1-3/4”	1-13/16”	1-3/4”	2”	1-1/4”
-20		1-7/8”		1-13/16”		1-5/16

10	Parker Hannifin Corporation
	Hose Products Division

Wickliffe, OH