Assembly / Bringing into use
QAttaching the feet 12 (see Fig. B)
jAttach the feet 12 from below through the mounting holes in the device‘s base plate.
jPlace the plain washers and then the nuts on to the screw threads.
jTighten the nuts using a size 10 open spanner.
QAttaching the dust blow tube 1 (see Fig. C)
jScrew the dust blow tube 1 clockwise into the opening provided for it.
QBringing into use
Take note of the mains voltage. The mains voltage at the mains socket must match that shown on the rating plate on the device. Devices marked with 230 V can also be operated at 220 V.
CAUTION! Make sure that the device is switched off before you connect it to the mains supply.
JAlways switch on the electrical power tool before moving the workpiece against it. Otherwise there is the risk of kickback.
Setting up the device:
jGrab the device at the position labelled “Bitte hier anheben - Please lift here” to position the device.
Switching on the device:
jPress the green ON button 4 .
Switching off the device:
jPress the red OFF button 3 .
QSetting the stroke rate
jTurn the stroke rate controller 2 clockwise to increase the stroke rate.
jTurn the stroke rate controller 2 anticlockwise to decrease the stroke rate.
10 GB/IE/CY
NOTE: Be aware that too high a stroke rate leads to the saw blade heating up, an increase in wear of the saw blade and burn marks on the material.
jSelect a saw speed suitable for the material being sawn.
| Maximum | Medium | Minimum |
| speed | speed | speed |
Thick woo- | Straight | Normal | - |
den board | cut | fretsaw |
|
|
| work |
|
Thin woo- | Straight | Normal | Intricate |
den or | and curved | and intrica- | fretsaw |
plastic | cuts | te fretsaw | work |
board |
| work |
|
QTilting the saw table 6 (see Figs. D, E)
jUnscrew the angle setting screw 5 .
jTilt the saw table 6 until the desired is reached.
NOTE: The angle can be read off the angle scale 6 a .
jRetighten the angle setting screw 5 .
QInserting / removing the saw blade 7
Warning! DANGER OF INJURY!
Pull the mains plug out of the socket before you carry out any task on the device,
Inserting the saw blade 7 :
jLift up the clamping lever 13 .
jInsert the saw blade 7 through the opening in the saw table 6 .
Ensure that the teeth of the saw blade 7 point forwards and downwards.
jSuspend the saw blade 7 in the bottom blade mount 14 .
jThen hook the top pin of the saw blade 7 in the recess provided for this purpose in the top saw blade mount 8 .
