General safety advice for electrical power tools / Preparing for use
Use sharp planer blades only.
Do not soak the materials or the sur- face you are about to work on with liquids containing solvents.
Avoid contact with rotating parts. Never use the device for a purpose for which it was not intended or with
Hold the device securely when work- ing. Ensure that you are standing in a stable,
Always keep the device clean, dry and free from oil or grease.
Original accessories/ attachments
Use only the accessories and attach- ments detailed in the operating instruc- tions. The use of attachments or accessories other than those recommended here could lead to you suffering an injury.
Preparing for use
Switching On / Off
Switching on:
First press the safety
Then press and keep pressed the ON / OFF switch 2 .
Switching off:
Release the ON / OFF switch 2 .
Note: For safety reasons the ON / OFF switch 2 cannot be locked in the ON position.
Setting the cutting depth
The rotary control 13 can be used to set the cutting depth in steps from 0 – 3.0 mm according to the cutting depth scale 14 .
Vacuum extraction of dust / debris (see Fig. A)
WARNING! DANGER OF INJURY! Before you carry out any work on the device al- ways pull the mains plug out of the mains socket.
Planing debris removal port (right / left selectable):
Release the planing debris removal port 3 by turning it against the direction of the arrow (out of the “Lock” position).
Pull the planing debris removal port 3 out of the device.
The planing debris removal port 3 can be set to face left or right in the planer.
Push the planing debris removal port 3 into the device.
Lock the planing debris removal port 3 by turning it into the “Lock” position.
External vacuum extraction:
If necessary fit the reducer piece 15 when using a dust extraction system, e.g. a workshop dust extraction system.
The vacuum cleaner / dust extraction device used must be suitable for the material being planed.
Connection:
Place the reducer piece 15 firmly on to the planing debris removal port 3 .
Push the hose of a suitable dust extraction device approved for that purpose (e.g. a workshop vacuum cleaner) on to the planing debris remov- al port 3 or the reducer piece 15 .
Removal:
Pull the hose of the dust extraction device off the planing debris removal port 3 or off the reducer piece 15 .
Pull off the reducer piece 15 , if fitted.
Parking shoe (see Figs. B / C)
The parking shoe 16 allows you to lay the device down without the risk of damaging the workpiece.
10 GB/IE/CY
