Introduction / General safety advice for electrical power tools
Included items | This can result in a much lower vibration load over |
| the whole of the period of working. |
1Electric planer PEH 30
1Guide fence
1 | Rebate depth stop | General safety advice for |
1 | Allen key | electrical power tools |
1Open spanner
1 | Reducer piece |
|
| WARNING! | Read all the safety advice |
1 | Operating instructions | and instructions! Failure to observe the safety | |||
|
| advice and instructions may result in electric shock, | |||
|
| fire and / or serious injury. | |||
Technical data
Rated voltage: | 230 V~ 50 Hz |
Rated power: | 750 W |
Design | n0 13,000 rpm |
Planing depth: | 0 - 3.0 mm |
Planing width: | 82 mm |
Protection class: | II / |
Noise and vibration data:
Values determined in accordance with EN 60745. The sound pressure level
Wear ear protection!
Evaluated acceleration, typical: Hand / arm vibration ah = 5,644 m / s2 Uncertainty K = 1,5 m / s2
WARNING! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. Different uses of the device give rise to different vibra- tion levels and in many cases they may exceed the values given in these instructions. It is easy to under- estimate the vibration load if the electrical power tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use.
KEEP ALL THE SAFETY ADVICE AND INSTRUC- TIONS IN A SAFE PLACE FOR FUTURE REFER- ENCE! THE TERM “ELECTRICAL TOOL” USED IN THE SAFETY ADVICE REFERS TO ELECTRICAL TOOLS POWERED BY MAINS ELECTRICITY (BY MEANS OF A MAINS LEAD) AND ELECTRICAL TOOLS POWERED BY RECHARGEABLE BATTER- IES (WITHOUT A MAINS LEAD).
1. Workplace safety
a)Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents.
b)Do not work with the device
in potentially explosive envi- ronments in which there are
inflammable liquids, gases or dusts. Electrical power tools create sparks, which can ignite dusts or fumes.
c)Keep children and other peo-
ple away while you are op- erating the electrical tool.
Distractions can cause you to lose control of the device.
2. Electrical safety
To avoid danger to
life from electric shock:
a)The mains plug on the device must match the mains socket. The plug must not be modified in any way. Do not use
GB/IE/CY
7
